Safety Quiz 16Using a Power Sander (Chapter 29)
1. When setting up a sanding operation, position the table
A) 3/4 inch from the sanding belt or disc.
B) 1/16 inch from the sanding belt or disc.
C) 1/2 inch from the sanding belt or disc.
D) Flush with the sanding belt or disc.
2. Avoid sanding wood with excess glue or surface finishing because
A) the materials could ignite.
B) toxic fumes could be produced.
C) the materials will ruin the abrasive.
D) such pieces are worthless scrap.
3. An incorrect use of a power sander would be
A) sanding dirt free, brand new wood.
B) smoothing rough textures on cut faces.
C) preparing surfaces for priming and painting.
D) shaping parts better shaped on other machines.
4. Which is the correct guideline for feeding stock into a power sander?
A) Feed the stock directly against the sanding belt or disc.
B) Feed the stock from the left of the sanding belt or disc.
C) Feed the stock from the right of the sanding belt or disc.
D) Feed the stock from slightly above the sanding belt or disc.
5. The best way to prevent friction burns to stock is to
A) pull the stock away from the abrasive about every 15 seconds.
B) keep the stock in motion when sanding.
C) wet the stock.
D) start with a chilled piece of stock.
Safety Quiz 3 Using Hand Tools (Chapter 2-5)
6. When using hand tools, always wear
A) eye protection.
B) leather gloves.
C) leather work shoes.
D) ear protection.
7. You find a tool that appears to be damaged. You should
A) try to fix it temporarily.
B) do nothing about it.
C) throw it away.
D) tell the teacher about it.
8. An important safety guideline that applies to cutting tools is
A) sharpen them twice a year.
B) dip them in oil before using.
C) keep them sharp at all times.
D) dip them in water before using.
9. If you are going to use a screwdriver on a part,
A) sharpen the screwdriver.
B) secure the part.
C) paint the part first.
D) hold the screwdriver in your left hand.
10. Use tools only in the way they were designed to be used.
A) True B) False
Safety Quiz 5 Using a Portable Drill (Chapter 6)
11. Install a drill bit in a drill only after disconnecting the ______source.
12. What word describes the necessary condition of any drill bit used?
A) shiny
B) oily
C) sharp
D) worn
13. You will use a chuck key to install a bit. Which safety statement applies?
A) Coat with graphite the end that inserts into the drill.
B) Wear insulated gloves when handling the key.
C) Remove the chuck key before starting up the drill.
14. You prepare a workpiece for drilling by any of the following except
A) clamping the workpiece to the top of a workbench.
B) using a pocketknife to mark a starter hole.
C) clamping the workpiece in a vise.
D) using an awl to mark a starter hole.
15. Before powering up the drill, be sure to
A) check the fuse box.
B) put on eye protection.
C) put on gloves.
D) notify your classmates.