Kingdom Radio Control Desk

For 18Cue & 20Cue Systems Instrctions

6th-Nov-2008

In order to meet the requirements of old and new customers, combined with years of experience in the development of the design, we designed this 12Channels Control Desk. It is used to control the old and new 18position and 20position receivers such as KFE2203E and KFE2204. This Control Desk is not only exquisite and fashion, but also simple and easy to use. Its professional water-proof design to ensure 100% waterproof, high-capacity battery to ensure super long standby time，professional safe design to the greatest degree of security to ensure the safety of users. It is predicated that this new control box is one of the best products in China market at present, we hope it can be well favored by old and new customers.

Consists

The field module(operation box) - 1pc

The 110v or 230v AC charger - 1pc

The safty key - 2pc

The rubber antenna - 1pc

Function Keys

A Power Switch.

B Safty Switch. Prevent accidental firing signal.

C Charger Socket. It can recharge the battery, the charging voltage is 15v, 500ma

D Battery Indicator. It can show three status: red blink means low battery; red means battery is charging; green means battery is full.

E Receiver Selection. There are 12 positions in all, the S position for special function.

F Antenna Socket

G Signal Indicator. Show stop and output state of the signal.

H Pause Switch. To suspend the firing for accidental things in order to prevent the accident to spread and to expand.

I Single Control Digital LED Screen.

J Digital LED Power-saving Button

K “Single” Firing Button

L “All” Firing Button

M “Step” Firing Button

N “Sequence” Firing Button

O “Confirm” Firing Button

Programming Instructions

1. Turn the Power Switch to the ON position, turn the Pause Switch to the CONT position, and turn the Safty Key Switch to the ON position.

2. Install the antenna to make sure the signal is good.

3. Choose the setting position to the Receiver. Cancel all the frequencies and the security codes previously programmed into the Receiver before a new setting. Push the Program button on Receiver and realease it immediately. Hold down one of the Firing Buttons (but STEP button) and Confirm Button of the Control Desk at the same time aboout 2 seconds. After that the setting is completed.

Special Directions

1. Please pay attetion to the S position in the Receiver Selection, it is our most special design. When the Receiver controled by this position, it can achieve Sequential firing between two adjacent receivers. It does not require cables to connect with(For more details of programming, please read the instructions of 18cue & 20cue firing system). We hope this special design can bring fire worker a special feeling.

NOTE: When using this function:

A. Rotate the knob to the S position.

B. The address should be set on the Receivers.

C. Make sure the same time on all Receivers.

D. The settings can be saved, next operating only need to restart the Power Switch.

2. When fire workers are installing the e-matches. Forbidden practicing the Control Desk!

3. If you find any malfunctions while operating this desk, please discontinue use immediately and contact your local supplier.

Under the SINGLE, STEP, ALL and SEQUENCE mode, please practice it according to following suggestions. You will find different effects of different settings:

A: Receiver in the same channel(no address codes)

B: Receiver in different channels(no address codes)

C: Receiver in S channel(address codes and same time setting)

1