(Journal of Periodontal & Implant Science: Research Article)
Title of your paper(capitalize only the first letter of the whole phrase)
First Author1, Second Author2, Third Author3,* [TK1]
1First affiliation, City, Country
2Second affiliation, City, Country
3Third affiliation, City, Country
Running Title: Limit60Characters
*Correspondence: Author name
Affiliation, Street Address, City, Postal code, Country
E-mail: , Tel: +Country code-xxxx-xxxx , Fax: +Country code-xxxx-xxxx
ORCID
Tae-Il Kim
John Doe
Jane Doe[TK2]
Author Contributions[TK3]
Conceptualization:Tae-Il Kim; Formal Analysis: John Doe, Jane Doe; Investigation: Tae-Il Kim, John Doe, Jane Doe; Methodology:Tae-Il Kim, John Doe, Jane Doe; Project Administration: Tae-Il Kim; Writing – Original Draft: Tae-Il Kim, John Doe, Jane Doe; Writing – Review & Editing: Tae-Il Kim
ABSTRACT
Purpose:
Methods:
Results:
Conclusions:[TK4]
Keywords: A; B;C; D; E; F[TK5]
INTRODUCTION[TK6]
Manuscripts should be submitted in Microsoft Word files. [TK7]They should be typed and double-spaced, using a font size of 10 with margins of 25 mm on each side and 30 mm for the upper and lower ends on A4 size paper.
Abbreviation
The use of acronymsand abbreviations is discouraged and should be kept to a minimum.When used, they are to be defined where first used, followed bythe acronym or abbreviation in parentheses.
Citation of reference
References should be numbered consecutively in the order in which they are first mentioned in the text. Each reference should be cited as [1], [1,4], or [1-3]. Whenquoting from other sources, give a reference number in bracket afterthe author’s name or at the end of the quotation.Examples are as follows:
-Kim [1]
-Bernstein and Horbar [2]
-Bradin et al. [3]
MATERIALS AND METHODS (primary section heading)
Primary section headings should be left justified, with all letters capitalized.
Subsection headings should be structured as follows:
Secondary subsection heading
Tertiary subsection heading
Quaternary subsection heading:
RESULTS
Tables and figures should be indicated in the main text as follows:
(Table 1), (Tables 1 and 2), (Tables 1-3), (Figure1A and B), (Figure1A-C), (Figures 1 and 2), (Figures 1-3), (Figures 1A and 3B), (Table 1, Figure2).
DISCUSSION
CONFLICT OF INTEREST
If there are any conflicts of interest, authors should disclose them in the manuscript[TK8].
ACKNOWLEDGEMENTS
Persons or institutes that contributed to the papers but not enough to be coauthors may be introduced. Funding information should be described along with other types of support, if any.
REFERENCES
References should not exceed 40.
Journal[TK9]
(Author. Title. Journalname Year:Vol;Page.)
1. Park JC, Um YJ, Jung UW, Kim CS, Choi SH, Kim CK. Histological characteristics of newly formed cementum in surgically created one-wall intrabony defects in a canine model. J Periodontal Implant Sci 2010;40:3-10.
2. Kim CS, Choi SH, Chai JK, Cho KS, Moon IS, Wikesjo UM, et al. Periodontal repair in surgically created intrabony defects in dogs: influence of the number of bone walls on healing response. J Periodontol 2004;75:229-35.
Book
(Author. Book title. Edition. Place: Publisher; Year.)
Newman MG, Takei HT, Klokkevold PR, Carranza FA.Carranza's clinical periodontology. 10th ed. St. Louis: Saunder Elsevier; 2006.
Book chapter
(Chapter author. Chaptertitle. In:editor(s). Book Title. Edition. Place: Publisher; Year. Chapter page.)
CarranzaFA, TakeiHH. Clinical Diagnosis. In: Newman MG, Takei HT, Klokkevold PR, Carranza FA.Carranza's clinical periodontology. 10th ed. St. Louis: Saunder Elsevier; 2006. p.540-60.
Web site
(Title [Internet]. Place: Publisher; Copyright year [cited Year Month Date]. Available from: URL.)
American Cancer Society. Cancer Reference Information [Internet]. Atlanta (GA): American Cancer Society; c2010 [cited 2010 Jun 20]. Available from:
Other types of references not described below should follow The NLM Style Guide for Authors, Editors, and Publishers (
TABLES
(sample)
Table 1. Comparison in thenumber of episodes of incontinence per 24 hours, urodynamic parameters, and QoL scores at baseline and after 24 weeks
Parameter / Baseline / Re-evaluation / P-value[TK10]PI / 68.40±12.18 / 33.60±9.08 / 0.000a)[TK11]
BoP / 42.60±17.66 / 19.70±9.31 / 0.002 a)
PD-M / 3.88±0.71 / 3.49±0.67 / 0.063
PD-O / 2.93±0.91 / 2.62±0.68 / 0.020 a)
CAL-M / 4.83±1.90 / 3.99±1.10 / 0.028 a)
CAL-O / 4.28±1.31 / 3.61±1.18 / 0.009 a)
Values are presented as mean±standard deviation.
PI:plaque index,[TK12]BoP:bleeding on probing,PD-M:probing depth-molar teeth, PD-O:probing depth-non-molar teeth, CAL-M:clinical attachment level-molar teeth,CAL-O:clinical attachment level-non-molar teeth.
a)Statistically significant difference compared to the baseline.
(Table guide)
Each table should be typed in aseparate sheet. The title of the table should be placedon top. The first letter of the first word should be capitalized and a period should not be placed at the end of the title. Tables are numbered in order of citation in the main text. Only horizontal lines should be used within a table, to distinguish the column headings from the body of the table, and immediately above and below the table.Lower case letters in superscripts a), b), c) ... should be used for special remarks.
FIGURE LEGENDS
(sample)
Figure1. [TK13]Histologic presentation of the biphasic calcium phosphate (BCP)/absorbable collagen sponge group after 4weeks of healing. (A) New bone is seen in close contact with the graft material. (B) BCP particle is absorbed without inflammation (A: H&E; B:H&E, bar=xxx nm). arrowheads, defect margin; NB, new bone.
(Figure guide)
You should not attach figure files in the manuscript. Instead, you should upload your figure files to our e-submission system while submitting your paper.
Figures should be submitted in Tiff or EPS file format and they will be automatically attached at the end of the manuscript in PDF. Number figures as Figure 1, Figure 2 … in order of citation in the figure legend. An individual should not be recognizable in the photographs unless a written consent of the subject has been obtained and is provided at the time of submission. Scales should be presented as a bar in the picture or as a magnification remark in the legend.
Except for especially complicated drawings that show large amounts of data, all figures are published at one page or one column width; when the figures are reduced to the size of a single column or of a single page width, the smallest parts of the figure must be legible.
It is recommended to size original figure widths to 4 inches wide.The minimum requirementsfor digital resolution are:
• 900 DPI/PPI for black and white images, such as line drawings orgraphs.
• 300 DPI/PPI for picture-only photographs.
• 600 DPI/PPI for photographs containing pictures and line elements,i.e., text labels, thin lines, arrows.
- 1 -
[TK1]-Author’s full name should be provided in order of first, middle, and last name.
-The superscript asterisk (*) sign should be given to the corresponding author.
-Do not write authors’ degrees and positions.
[TK2]Please refer to ORCID ( and provide ORCID code for every authors.
[TK3]The contributions of all authors should be described in cover page of the manuscript using the CRediT Taxonomy of author roles. They should be precisely reflected as following 14 categories: Conceptualization, Data curation, Formal analysis, Funding acquisition, Investigation, Methodology, Project administration, Resources, Software, Supervision, Validation, Visualization, Writing – original draft, Writing-review & editing.
All authors must meet at least one of the seven core contributions (Conceptualization, Data curation, Formal analysis, Investigation, Methodology, Software, Validation), as well as at least one of the writing contributions (Writing - original draft preparation, Writing - review & editing). Authors could also satisfy the other remaining contributions; however, these remaining contributions alone would not qualify them for authorship.
An individual author may be assigned multiple roles, and a given role may be assigned to multiple authors. It is recommended that corresponding authors bear the responsibility for role assignment of all authors who should be given the opportunity to review and confirm their assigned roles.
[TK4]-Structured formatas follows.
-Limit300 words.
[TK5]-Keywords should be main heading terms of MeSH ( in an alphabetical order.
-Limit 6 keywords, separated by semicolons.
[TK6]Research article should be structured as following section headings:
INTRODUCTION
MATERIALS AND METHODS
RESULTS
DISCUSSION
CONFLICT OF INTEREST
ACKNOWLEDGEMENTS
[TK7]Read these brief guides and overwrite from here.
[TK8]If there are noconflicts of interest, authors should insert the following sentence.
“No potential conflict of interest relevant to this article was reported”.
[TK9]First 6 authors are listed; thereafter add an ‘et al.’after the sixth author.For a journal article writtenby six or fewer authors, provide the names of allthe authors.
You can download the Endnote style file from the JPIS website.
[TK10]“P” should be written in capitalized and Italic style.
[TK11]Lower case letters in superscripts a), b), c) ... should be used for special remarks.
[TK12]Elaborate upon abbreviation.
[TK13]A legendfor each light microscopicorelectron microscopic photographshould include name ofstain with internal scale description. Magnification rate is not recommended.