Jansen Tore

Fibre glass sectional door Sun Line (Strength 80mm)

  • Ideal in order to create bright halls suffused with light.
  • Convincing through its shadowless illumination of rooms.

Door leaf:

The fibre glass sections are surrounded by 80 mm thick aluminium profiles. For door systems up to 12,000 mm door width the 80 mm door panel is implied due to its high inherent stability. Endurance tests have shown that the 80 mm thick door leaf can be implemented up to a width of 12 metres in a flush execution without additional enforcements (wind load class 3). In tests at a door width of 10 metres wind load class 4 was achieved. Apart from a high stability and good heat transfer coefficients the fibre glass sectional door ensures bright rooms suffused in light and a shadowless illumination. The fibre glass can be delivered in two colours “crystal” and “turquoise”. The castors are inserted in the front side of the sections and are not visible in mounted condition. The floor and lintel sealing consist of EPDM profiles with a lip seal.

Surface:

Structural surface in two colours “crystal” and “turquoise”. Upper, lower and lateral profiles consist of natural aluminium. The frames can be painted in RAL to choice if so required.

Fittings:

Standard fittings for a lintel height of at least 750 mm at a door leaf thickness of 80 mm. Further types of fittings such as high lift fittings, fittings for slanted roofs or vertical fittings are possible.

Guide rails:

The vertical guide rails come with an inner and outer profile seal up to the lintel, a round anti-trap protection as well as an integrated track cable duct.

Operation:

Manually via a hand chain or an electric drive. Individually adjusted springs above the lintel ensure a balanced running of the door. For large doors, doors with frequent cycles or higher speed an electric drive without spring compensation is advisable. This advantageous drive technology is very maintenance-friendly and ensures a long lifespan.

Supplementary equipment:

· Heat transfer coefficients can be improved with slots in the sections

· Body soundproofing of the guide rails

· Safety features (light barrier, flash light and/or omnidirectional light)

· Impulse transmitter (push button, key switch, pull switch, code switch, radar detector)

· Radio control

· Light barrier

· Induction loop

· Further equipment on request

Approved/verified according to:

DIN EN 13241-1.

Time of delivery:

The standard version can be delivered within five days.