Taro Shinjuku1*, Jiro Tokyo1, Nijiko Oozora2, Delete Numerals for a Single Affiliation2, 3

― Regular Paper ―

Template for Submission of a Manuscript to the “Journal of Japan Society for Atmospheric Environment” (Times New Roman 14pt, Centered, and Single Spaced if Two or More Lines Are Required)

1 Japan Society for Atmospheric Environment, 1-29-8 Shinjuku, Shinjuku-ku, Tokyo 160-0022, Japan

2 Graduate School of Science, All Japan University, 00-000 Ekimae, Tokyo 103-0000, Japan

3 Upper Air Measurement Co. Ltd., 1-1 Kengamine, Fujisan, Suruga 418-0000, Japan

*Corresponding author: (E-mail)

The Journal of Japan Society for Atmospheric Environment (JSAE) is a journal devoted to the publication of original papers concerning all aspects of atmospheric environment research. Manuscripts should contain new and significant findings, of which the contents have not been published in any other journal. Each manuscript is classified as a Regular Paper, Note, Rapid Report or Technical report.

(Abstract should not exceed 200 words, or about 10 lines, as a rule. Consciousness of this limitation is highly requested. )

Key words : Acid rain, Acid deposition, Wet deposition, Dry deposition, Forest ecosystem, Transboundary transport (No more than six items)

1. Introduction (Bold, put 1/2 blank line above and below the section title)

1.1 Fundamentals (Bold)

Manuscripts should be categorized as Regular Paper, Note, Rapid Report, or Technical Report. These are classified by the principle stated in the “Instructions for Authors”. The author is requested to refer to the “Instructions for Authors” and to prepare the manuscript in conformity to it.

In the first place, show the category of the manuscript at the top left corner of the title part, where a default -Regular Paper- is previously indicated. The font is Arial.

1.2 Style of the title part of the article

The title part includes (1) title, (2) authors’ full names, and (3) authors’ institutions and addresses. These are all in central alignment, and single spaced, with an exception that half space is prescribed above and below the part (2). In case that the part (2) extends over 2 lines, readjust the line space so as to remain half space only above the first line and below the last line.

In case of a single author or authors of a single institution, avoid any numeral indicating their relation.

2. Remarking points in preparing a manuscript

(1) Page disposition should be fixed as

Margins: Top 20 mm, and others 15 mm

Center space: 7 mm

Number of lines: 50

Authors are requested to refrain from changing this disposition.

(2) Section headings and subsection headings have to follow this template in their style and line space. Arbitrary heading style is allowed for further sub-sectioning.

(3) In the abstract, authors should summarize their objective of the research, methods and conclusions. References to figures, tables and literatures given in the main body of the article should be omitted because they are not available to abstracting services.

(4) Abstract in Japanese is recommended to be given at the last part as shown in this template. In particular, Japanese authors who intend to display their affiliations and addresses in Japan can do it only here.

3. Figures and tables

3.1 General remarks about figures and tables

In preparing figures and tables, follow the instructions below, which are quotations from the “Instructions for Authors”.

(1) Tables should be prepared in a form consistent with recent issues of this journal and should be consecutively numbered with Arabic numerals. Explanatory material should be given in the table legends and footnotes.

(2) Figures: Submit an original figure. Line drawings must be clear, with high black and white contrast. Each figure should be consecutively numbered with Arabic numerals. Appropriate sized numbers, letters and symbols should be used, no smaller than 1.5 mm in size. Set the line width to greater than 0.5 point (about 0.2 mm). Create your figures using applications that are capable of preparing camera-ready file acceptable for publication. The author will be charged for each color page.

3.2 How to insert figures and tables

Occasionally, the positions of figures (or tables) pasted in the text are unstable. In order to make the manuscript with their positions certainly fixed, the following way of insertion is recommended.

(1) Copy the figure on the source file.

(2) Make a blank line at the aimed position, and put the caret on the line.

(3) From the Edit menu, paste with the selection of “Picture” type.

(4) After selecting the pasted figure by clicking, pull down the Style menu and select “Object”. In the Object dialogue box, select “Layout” tab, and confirm the disposition is In-line.

(5) Arrange the size and position of the figure by putting the cursor at its bottom right and the caret at the bottom left corners, respectively, and adjusting them.

(6) Give the figure caption on the next line(s) of each figure. Give the title and other explanations on the previous line(s) for a table.

(7) Use “MS Gothic font” in figures and “Times New Roman” in tables

Table 1 Maximum number of pages, letters and words.

Type of Paper / Total
（Pages） / Japanese
abstract
（letters） / English
abstract
（words）
Regular Paper / 8 / 600 / 200
Note / 6 / 500 / 200
Rapid Report / 4 / 300 / 200
Technical Report / 8 / 600 / 200
Review Paper / 8 / 600 / 200

Fig.1 Example figure in order to indicate how to put a figure and write a caption in the manuscript.

(Received: Mon. DD. 20YY) (Accepted: Mon. DD. 20YY)

(These dates will be supplied by the editors.)

References (follow the example below)

Bladley, Y. A.: Carcinogenicity of ・・・・, J. Atmos. Environ., 85, 156-161 (1995a).

Bladley, Y. A.: ・・・・ (1995b).

Lunau, F., Reynollds, G. L.: Indoor Air Quality and Ventilation, 2nd ed., pp.122-126, Selper Ltd., London (1990).

Holst, P. A. J.: Bioaerosol related health effects of indoor air (Indoor Air Quality and Ventilation, Lunau, F., Reynolds, G. P. ed., 470, Selper Ltd., London), pp.331-338 (1990).

「投稿規程」および「投稿の手引」に準拠した原稿作成のための

テンプレート (14pt 中央揃え，2行以上の場合は行間1行)

新宿　太郎1, 東京　次郎1, 大空　虹子2, 所属が単一の場合は番号不要2, 3

1 (例) 社団法人　大気環境学会 160-0022　東京都新宿区新宿　1-29-8

2 著者全員の所属が単一の場合は、2行目以下を削除し、1行目の頭の数字1も削除してください。

3 この欄 (著者の所属。住所) は中央揃えではなく、左に適当なインデントを設定してください。

It is recommended to prepare the abstract written in Japanese here, however it is essential.

和文要旨の長さの目安は600 字であり、約10行です。速報ではその半分です。大幅な超過とならないよう努力をお願いします。大気環境学会誌は平成20年1月発行の第43巻、第1号からＡ４判にて発行されています。それを機会に原稿はCD-Rの電子ファイルに指定のページ設定にて作成して提出することとなりました。従来は、原稿を本文、図表、写真等、ばらばらで提出していたので、著者も査読者も、編集が終わり製版され校正刷りが出来るまで完成状況が判りませんでした。Ａ４判にての発行を機に、著者自身が完成版をイメージしながら、原稿を本テンプレートに貼り付け、図表や写真も配置したうえで投稿していただくこととなり、採用決定の段階で提出される原稿はそのままの形で刷り上ります。この方法により、投稿は1枚のCD-Rですみ、査読過程等も電子メールの通信で可能となり、刊行までの手続きが効率化します。ご協力をお願いします。

なお、本テンプレートは2012年8月20日に改訂しました。