2016 Sucker Rod Pumping WorkshopPage 1

ALRDC/SWPSC 2016 International Sucker Rod Pumping Workshop

Exhibit Area Registration Form

September 27 - 30, 2016

Please complete this form to register for an exhibit area at the ALRDC/SWPSC 2016 International Sucker Rod Pumping Workshop. Please do not write in the shaded spaces.

Note: The technical Workshop is on Thursday and Friday, Sept. 29 and 30. However, we would like to have the exhibits in place for the Continuing Education classes on Tuesday and Wednesday, Sept. 27 and 26, as well as for the Workshop. So, the exhibits should be installed on Monday afternoon, Sept. 26, at 5:00 or later, and can be torn down on Friday afternoon, Sept. 30, after lunch. However, if you wish, you can install them on Wednesday evening, after the Workshop reception is over.

Registration Information / Information Required for Registration
Exhibitor Contact Name
Company
Mailing Address
City/State/Zip Code
Country
Telephone Number
FAX Number
E-Mail Address
Method of Payment? Check or Credit Card
If check, see instructions below.
If credit card: (e.g. American Express, Visa, Master Card, Discover)
Credit Card Type:
Credit Card Number:
Name Printed on Credit Card:
Expiration Date:
Billing Zip Code:
Desired Exhibit Size
Small, Medium, or Large? See costs below.
Person using complimentary registration:
Additional Personnel (To work exhibit only – no courses or workshop)
Name / Email Address / Number of days working exhibit / Total Fee
($150 per day)
Cost of Exhibit Areas / Before August 29, 2016 / After August 29, 2016
Medium (10' x 10') (pop-up booth size) / $775 / $875
Large (10’ x 20’) / $1,275 / $1,375
Free registration. One free workshop registrationfor technical sessions only will be granted per exhibiting company.
Cost to staff the exhibit only. Cost per person to see/staff exhibits only, and not attend technical presentations, is $150 per day. Please complete the form above for those working the exhibits only. If personnel wish to attend the continuing education courses or the workshop, please complete the standard registration form at
Exhibit size. Please make certain your exhibit/display items fit within the size you have selected. There is no forklift available at the convention center. Storage of crates and large items is very limited. If any change is needed in the exhibit size or other requirements, please notify Ronda Brewer immediately. Information about shipping/receiving exhibit materials will be sent out at prior to the workshop date. Please check this website for periodic updates.
Set up Time. Exhibits may be set up any time after 4:00 pm on Monday, Sept. 26, 2016.
Teardown time. Please do not start teardown of your exhibit until after lunchon Friday, 23rd. If you must start teardown early, please coordinate with Ronda Brewer at the Workshop administration table.
Door prizes. If you would like to provide door prizes in your booth, this is permitted. Also, if you would like to donate door prizes to be distributed during the general sessions, this will be appreciated.

(a)electronic: (Save as an attachment and email)

(b)Fax: 1-806-742-3502

(c)Mail: Sucker Rod Pumping Workshop

Petroleum Engineering Department

Texas Tech University, Box 43111, Lubbock, Texas 79409-3111

(d) Telephone: 1-806-834-7937

If paying by check, make it out to Southwestern Petroleum Short Course, indicate 2016 International Sucker Rod Pumping Workshop, and mail it to the address given above.