2000 ODYSSEY - Dashboard Center Panel Removal/Installation
NOTE:
· When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
· Take care not to scratch the dashboard and related parts.
1. Remove the steering column covers.
2. Carefully detach the clips, then remove the center panel (A). Disconnect the heater control panel connectors (B) or climate control unit connectors, rear A/C control dial (C) (for some models) and interior light switch connector (D). With navigation system, disconnect the hazard warning switch connector, rear A/C control dial, and interior light switch connector. For '03-04 models: Disconnect the passenger's airbag off indicator connector.
3. Install the panel in the reverse order of removal, and note these items:
· Make sure each connector is plugged in properly.
· Push the clips into place securely.
2000 ODYSSEY - Audio Unit Removal/Installation
SRS components are located in this area. Review the SRS component locations, '99-01 models, '02 model, '03-04 models, and the precautions and procedures in the SRS before performing repairs or service.
NOTE:
· Put on gloves to protect your hands.
· Take care not to scratch the dashboard and related parts.
1. Make sure you have the anti-theft codes for the radio and the navigation system, then write down the frequencies for the radio's preset buttons.
2. Remove the center panel
3. Disconnect the audio unit connector (A) and the antenna lead (B) from the audio unit.
4. Remove the screws (A) and the audio unit (B).
5. Install in the reverse order of removal, and note these items:
· Make sure the audio unit connectors are plugged in properly, and the antenna lead is connected properly.
· Enter the anti-theft codes for the radio and the navigation system, then enter the customer's radio station presets.