1. Do Not Use Compressed Air to Clean Bolster Plates, Holes Or T Slots

Die setters

Note: Before working on any press or die, shut off the power to the drive motor, lock and tagout unit.

1. Do not use compressed air to clean bolster plates, holes or "T" slots.

2. Do not use finger to locate or line up holes; use a drift pin or sight visually.

3. Use a ladder or platform when working beyond reach from floor level to hook up a die or make slide or feed cam adjustments.

4. Do not start press unless all guards or point-of-operation safeguarding devices are in place and operating.

5. Do not release press for use until first removing all parts, tools and foreign materials.

THE INFORMATION PRESENTED IN THIS “SAMPLE” SAFETY PROGRAM HAS BEEN COMPILED FROM VARIOUS SOURCES BELIEVED TO BE RELIABLE. HOWEVER, IT CANNOT BE ASSUMED THAT ALL ACCEPTABLE MEASURES ARE CONTAINED IN THIS PROGRAM WITH REGARDS TO YOUR INDUSTRY STANDARDS AND REQUIREMENTS UNDER PARTICULAR FEDERAL, STATE, PROVINCIAL AND LOCAL LAW.