This is simply a format to work to. It will ensure that all (or nearly all) requirements are considered. There may be nothing to enter in some of the headings. Keep entries short and simple.
Project:
Method Statement Prepared By:
Site Address:
Method Statement No.:
Revision: / Air Source Heat pump and plumbing installation
Dave Prout
Ambulance Station, Unit 5 Libby Court, Kingsmill Road, Saltash.
MS 232
0
Scope of Works: / To supply and install all necessary copper pipework, thermal store and air source heat pump to provide an operating heating system.
To carry out plumbing works to accommodation area.
Access / Egress: / Access to the Ambulance Station will be through main entrance or roller shutter doors.
Lighting: / The lighting within the site is good and no additional will be required, unless working above the ceiling where good levels of daylight are normally adequate through skylights. No work will be permitted externally if natural daylight is not sufficient.
Plant and Equipment used: / Pulse Services Ltd steps.
PulseServicesAluminiumTower.
Pressure test pump
Hand Tools
Soldering Torch
Drills
Materials used: / Delonghi Air Source Heat Pump
ACV Smartline thermal store
Copper pipework
Copper Fittings
Rockwool bright finish insulation
Bespoke control panel
Glycol
Flux
Solder
Sequence of Tasks: / Arrive on site and immediately report to the station Crew. Sign in to site and complete all health and safety documentation required. Familiarise oneself with the fire protection systems, fire fighting equipment and emergency exits.
Discuss the task with the station crew and make them aware of the works to be carried out and the area to which access will be temporarily suspended.
On completion the Smartline cylinder, Delonghi Heat Pump can be installed with all interconnection pipework and power supplies into the existing boiler room.
Handover to the client is set for the end of works.
Risks and Controls: / Hot Works
Ensure that temporary covers are installed to smoke detectors within the area of work during soldering of joints. Ensure fire fighting equipment is to hand during hot works. Finish all hot works at least one hour before completing works for the day and a final inspection of the area is carried out before leaving site. Ensure that all smoke heads are uncovered and system operational before leaving site.
The following risks and control measures have been identified: See Risk Assessment index for detailed assessments:
- Working with electricity
- Working with high temperature plant
- Working at heights, step Ladders.
- Hot works
- Loan working
- Manual handling
- Staff contact
- Working with revolving parts
- Working among trip hazards
- Cleaning
- Working with steel panels
Technical Information: / Manufactures installation details supplied.
Relevant codes of practise.
Best working practise.
Emergency Arrangements: / In case of emergency dial 999 and report the incident.
Nearest A&E
- Derriford Hospital
- (5.3 miles)
- Derriford Road, Crownhill, Plymouth, Devon, PL6 8DH
- Tel: 0845 155 8155
Training: / Engineers will be fully qualified and competent to carry out the works to which they have been tasked.
Supervision: / Contract Manger; Dave Prout 07971 538 978
Office; 01749 670 838
Fax; 01749 679 190
e-mail;
Housekeeping and Waste Removal Procedure: / All waste to be removed from site by the attending engineers and returned to Pulse Services for disposal / re-cycling.
Risk/COSHH/Noise/Manual Handling Assessments:
COSHH Assessments:
Risk Assessments:
Manual Handling Assessments:
Noise Assessments: / CA015 Glycol, CA017 Solvent Glue, CA021 Flux Paste, CA028 Boss super green, CA029 Boss white, CA031 PTFE, CA033 Solder
RA259
MH155
N/A
Date of compilation: / 28th January 2011