Voodoo Hex Exhaust Hayabusa
VEZX636L3
Voodoo Exhaust 13-16 ZX636
** Voodoo exhaust systems are not DOT or EPA approved for highway use. Voodoo Industries, LLC assumes no liability for damages in conjunction with our exhaust system. Voodoo exhaust is designed for off-road, show purposes only and any other use is the liability of the purchaser. See Disclaimer for specifics**
- Once system is installed or run on your motorcycle, it is non-returnable
- Remove stock muffler and mid-pipe/Catalytic Converter
- Remove the front seat
- Mark the exhaust valve servo position
- Carefully remove the exhaust valve cables
- Remove the exhaust servo bolt using a tamper proof torx bit (hold the servo pulley in place while doing so to prevent damage)
- Remove the (2) phillips head screws
- Install the servo motor bracket using the stock screws
- Install the stopper plate using the stock torx bolt (hold the servo pulley in place while doing so to prevent damage)
- Slide new exhaust clamp on stock exhaust outlet then slide the VooDoo exhaust INTO the header outlet (the stock gasket will not be used)
- Attach the exhaust to the stock mounting location of the catalytic converter using the supplied bolt, nut, and washer (leave loose at this point)
- Tighten the exhaust clamp
- Tighten the mounting bolt
- Power Commander may be necessary for optimum performance
10/8/2014
Emissions Notice to Customers in California
California regulates motorcycle aftermarket parts that have the potential to impact emissions. In most cases, the sale and use of emissions related aftermarket parts on motorcycles is prohibited unless it is either a “replacement part” as defined by California, or is a specifically authorized use of that part as reflected in an Executive Order (“EO Part.”)
The California Air Resources Board (ARB) regulates aftermarket parts and has promulgated regulations that essentially place all emissions related aftermarket parts into three categories:
(1) Replacement Parts
Replacement Parts are aftermarket parts that ARB considers to be functionally equivalent to the stock part they are intended to replace, and therefore would not impact the emissions from these vehicles. These parts are appropriate for sale and use on motorcycles used on or off the public highways. For aftermarket exhaust systems and parts, there are two applicable scenarios:
(a) If the motorcycle’s stock exhaust system does not contain a catalytic converter, then an aftermarket exhaust part is a replacement part as long as the part does not remove or replace any emission control equipment originally attached to the stock exhaust system, such as oxygen sensors.
(b) If the motorcycle’s stock exhaust system contains a catalytic converter in the manifold section of the stock exhaust system, then an aftermarket muffler positioned downstream from the catalytic converter (i.e. cat-back) is a replacement part as long as the part does not remove or replace any emission control equipment originally attached to the stock exhaust system.
(2) Executive Order Parts
Executive Order Parts are aftermarket parts that ARB has evaluated and determined do not adversely impact emissions, and thereby are granted an Executive Order (EO), which allows the part to be sold and used on specified motorcycles. Any aftermarket exhaust system that replaces or otherwise impacts emission control equipment, including catalytic converters, requires an EO to be sold and used on a motorcycle used on or off a public highway.
(3) Competition Use Only Parts
Competition Use Only Parts may not be sold or used on a motorcycle that is used on or off the public highways other than those motorcycles used exclusively for competition. Competition Use Only Parts are aftermarket parts that replace or otherwise interfere with the operation of an emission control device, such as a catalytic converter or oxygen sensor, and may be sold and used on a motorcycle that is used only for closed course competition.
10/8/2014
Disclaimer
“Read Before Installation”
Voodoo Industries, LLC suggests installation of your product by a qualified technician. Failure to install any Voodoo Industries, component properly can/will cause damage. Voodoo Industries, cannot be held liable for parts used in any other manner than they are intended. All parts are designed for show use only. Voodoo Industries, is not a certified DOT aftermarket supplier, thus use of products manufactured/supplied by Voodoo Industries, for competition or on public highways voids any and all warranties and may be a violation in your area. Competition Use Only Parts may not be sold or used on a motorcycle that is used on or off the public highways other than those motorcycles used exclusively for competition. Competition Use Only Parts are aftermarket parts that replace or otherwise interfere with the operation of an emission control device, such as a catalytic converter or oxygen sensor, and may be sold and used on a motorcycle that is used only for closed course competition.
Limited Warranty
Voodoo Industries, manufactured products are guaranteed to be free from defects in materials and workmanship for one year from date of purchase. Matte black coated mufflers will be covered under this warranty. FULL EXHAUST SYSTEMS WITH MATTE BLACK COATING ARE NOT COVERED UNDER THIS WARRANTY. Misuse and corrosion of product will not be warranted. Chroming, or any surface treatment, of parts voids any warranties. Within 12 months product will be replaced or repaired at no charge, except shipping. Voodoo Industries, reserves the right to review or refuse claims due to misuse, wrongful installation or modification of product. Voodoo Industries, is not responsible for any labor charges on warranty claims. Retailer, installer, or distributor is responsible for supplying end user with Warranty information. Proof of purchase is required for any claim. This is a non-transferable warranty awarded to the original purchaser and does not apply to commercial or unreasonable use or damage to the product.