The 17th Symposium on Measuring Techniques in Transonic and Supersonic Flow in Cascades and Turbomachines
STOCKHOLM – SWEDEN
9 & 10 SEPTEMBER 2004
PRELIMINARY BOOK OF ABSTRACTS
Thursday 9 September
08:00 – 08:30Registration and coffee
08:30Welcome and Introduction
08:45 – 10:25Session 1: Measurement Methodologies 1 (4 papers)
10:25Coffee
10:55 – 12:10Session 2: Laser Measurement Methods I (3 papers)
12:10Lunch
13:50 – 15:30Session 3: Optical Measurement Techniques (4 papers)
15:30Coffee
16:00Heat and Power Technology Lab Tour (KTH, Brinellvägen 78)
Fluid Mechanics Department Lab Tour (KTH, Teknikringen 8)
19:00Symposium Dinner
Friday 10 September
08:30 – 09:45Session 4: Laser Measurement Methods II (3 papers)
09:45Coffee
10:15 – 11:55Session 5: Instrumentations & calibrations (4 papers)
11:55Lunch
13:35 – 14:50Session 6: Probe Measurement Methods (3 papers)
14:50Coffee
15:20 – 16:35Session 7:Measurement Methodologies 2 (3 papers)
16:35Final Discussions and Close
The 17th Symposium on Measuring Techniques in Transonic and Supersonic Flow in Cascades and Turbomachines
STOCKHOLM – SWEDEN
9 & 10 SEPTEMBER 2004
Session 1 – Measurement Methodologies 1
Thursday 9 September, 08:45 – 10:25
Session chair: ?
Paper 1-1: “”
Ivey, P.
EVI-GTI
Paper 1-2: “DATA REDUCTION METHOD FOR THREE-DIMENSIONAL TRANSONIC FLOW MEASUREMENTS”Šafařík, P.; Luxa, M.
Institute of Thermomechanics, Academy of Science of the Czech Republic, Prague, Czech Republic.
Benetka, J.; Michálek, J.
Aeronautical Research and Test Institute, Prague, Czech Republic.
Paper 1-3: “a new test facility for evaluation of parameters defining nozzle guide vane endwall heat transfer”
Rubensdörffer, F.
Demag Delaval Industrial Turbomachinery AB, Dep. of Research and Development, Finspong, Sweden.
Fransson, T. H.
Chair of Heat and Power Technology, Royal Institute of Technology, Stockholm, Sweden.
Paper 1-4 “TEMPERATURE MEASUREMENTS IN TURBINE COLD FLOW RIGS”Vazquez, R.
ITP, San Fernando de Henares, Spain.
Coffee, 10:25
The 17th Symposium on Measuring Techniques in Transonic and Supersonic Flow in Cascades and Turbomachines
STOCKHOLM – SWEDEN
9 & 10 SEPTEMBER 2004
Session 2 – Laser Measurement Methods IThursday 9 September, 10:55 – 12:10
Session chair: ?
Paper 2-1: “PRELIMINARY STEPS IN THE DEVELOPMENT OF DOPPLER GLOBAL VELOCIMETRY AT VKI”
Bagnera, C.; Sakaguchi, D.
Von Karman Institute for Fluid Dynamics, Turbomachinery and Propulsion Department, Rhode St Genèse, Belgium.
Paper 2-2: “PDA AND PVI MEASUREMENTS IN A 2-PHASE-FLOW TRANSONIC CASCADE WIND TUNNEL”
Ulrichs, E.; Joos, F.
Laboratory of Turbomachinery, Helmut-Schmidt-University, University of the Federal Armed Forces Hamburg, Germany.
Paper 2-3: “AN OPTICAL TIME RESOLVED MULTIPLE-PULSE PIV DIAGNOSTIC FOR VISUALISING TURBULENT STRUCTURES IN HIGH SPEED AIRFLOWS”
Dunkley, P.; Skeen, A.; Timmerman, B. H.; Bryanston-Cross, P. J.
Optical Engineering Laboratory, University of Warwick, Coventry, UK.
Lunch, 12:10
The 17th Symposium on Measuring Techniques in Transonic and Supersonic Flow in Cascades and Turbomachines
STOCKHOLM – SWEDEN
9 & 10 SEPTEMBER 2004
Session 3 – Optical Measurement TechniquesThursday 9 September, 13:50 – 15:30
Session chair: ?
Paper 3-1: “COMPOSED OPTICAL RECORD TECHNIQUE”
Ulrych, J.
Aeronautical Research and Test Institute, Prague, Czech Republic.
Paper 3-2: “HIGH-SPEED DIGITAL SHADOWGRAPHY FOR HIGH-FREQUENCY SHOCK TRACKING IN SUPERSONIC FLOWS”
Timmerman, B. H.; Bryanston-Cross, P. J.; Skeen, A. J.; Tucker, P. G.; Jefferson-Loveday, R.; Dunkley, P.
Optical Engineering Laboratory, University of Warwick, Coventry, UK.
Paduano, J.; Guenette Jr., G. R.
Gas Turbine Laboratory, Massachusetts Institute of Technology, Cambridge MA, USA.
Paper 3-3: “CALIBRATION AND USE OF PRESSURE SENSITIVE PAINT (PSP) FOR A TRANSONIC FLOW APPLICATION”
Tillmark, N.; Alfredsson, P. H.
KTH Mechanics, The Royal Institute of Technology, Stockholm, Sweden.
Paper 3-4: “Experimental techniques used in the NASA GRC Transonic Flutter Cascade - Part 1: steady state measurements”
Lepicovsky, J.
QSS, NASA GRC, Cleveland, USA.
Coffee, 15:30
Heat and Power Technology & Fluid Mechanics Department Lab Tour, 16:00
(KTH, Brinellvägen 78 & Teknikringen 8)
Symposium Dinner, 19:00
The 17th Symposium on Measuring Techniques in Transonic and Supersonic Flow in Cascades and Turbomachines
STOCKHOLM – SWEDEN
9 & 10 SEPTEMBER 2004
Session 4 – Laser Measurement Methods IIFriday 10 September, 08:30 – 09:45
Session chair: ?
Paper 4-1: “DEVELOPMENT OF A THREE-COMPONENT DOPPLER GLOBAL VELOCIMETRY SYSTEM”
Hawkes, G. S.; Thorpe, S. J.; Ainsworth, R. W.
Department of Engineering Science, University of Oxford, UK.
Paper 4-2: “LOW SPEED LINEAR CASCADE CHARACTERIZATION THROUGH LASER TECHNIQUES”
Lazaro, B.; Gonzalez, E.
School of aeronautics, UPM Madrid, Spain.
Vazquez, R.; Cadrecha, D.
ITP, San Fernando de Henares, Spain.
Paper 4-3: “LASER 2 FOCUS (L2F) MEASUREMENT OF INLET AND OUTLET BOUNDARY LAYER IN THE VM 100 WINDTUNNEL”
Kessar, A.; Fransson, T. H.
Chair of Heat and Power Technology, The Royal Institute of Technology, Stockholm, Sweden.
Coffee, 09:45
The 17th Symposium on Measuring Techniques in Transonic and Supersonic Flow in Cascades and Turbomachines
STOCKHOLM – SWEDEN
9 & 10 SEPTEMBER 2004
Session 5 – Instrumentations & Calibrations
Friday 10 September, 10:15 – 11:55
Session chair: ?
Paper 5-1: “IMPROVED RUGGEDISED HIGH TEMPERATURE PRESSURE TRANSDUCERS FOR GAS TURBINE ENGINE & COMPONENT RIG RESEARCH & DEVELOPMENT”
Kurtz, A. D.; Chivers, J. W. H.; Ned, A. A.
Kulite Semiconductor Products Inc., Leonia NJ, USA.
Epstein, A. H.
Massachusetts Institute of Technology, Cambridge MA, USA.
Paper 5-2: “A TECHNIQUE FOR USING RECESSED-MOUNTED PRESSURE TRANSDUCERS TO MEASURE UNSTEADY PRESSURE”
Vogt, D. M.; Fransson, T. H.
Chair of Heat and Power Technology, The Royal Institute of Technology, Stockholm, Sweden.
Paper 5-3: “dynamic response of pressure sensitive electret film sensor”
Fridh, J.; Vogt, D. M.; Fransson, T. H.
Chair of Heat and Power Technology, The Royal Institute of Technology, Stockholm, Sweden.
Olkkonen, H.; Heikkinen, P.
University of Kuopio, Dept. of Applied Physics, Kuopio, Finland.
Paper 5-4: “Experimental techniques used in the NASA GRC Transonic Flutter Cascade - Part 2: Unsteady measurements”
Lepicovsky, J.
QSS, NASA GRC, Cleveland, USA.
Lunch, 11:55
The 17th Symposium on Measuring Techniques in Transonic and Supersonic Flow in Cascades and Turbomachines
STOCKHOLM – SWEDEN
9 & 10 SEPTEMBER 2004
Session 6 – Probe Measurement Methods
Friday 10 September, 13:35 – 14:50
Session chair: ?
Paper 6-1: “DEVELOPMENT OF HIGH RESPONSE PRESSURE PROBES FOR TIME-RESOLVED 2D AND 3D FLOWS MEASUREMENTS IN TURBOMACHINES”
Dossena, V.;Gaetani, P.; Persico, G.
Dipartimento di Energetica, Politecnico di Milano, Milano, Italy.
Paper 6-2: “PROBE MEASUREMENT ERROR CAUSED BY SHEAR FLOW”
Appukuttan, A.; Miller, R. J.; Hodson, H. P.
Whittle Laboratory, University of Cambridge, UK.
Paper 6-3: “FLOW ADAPTIVE AERODYNAMIC PROBE FOR TURBOMACHINERY FLOWS”
Lenherr, C.; Oschwald, M.; Kalfas, A. I.; Abhari, R. S.
Turbomachinery Laboratory, Swiss Federal Institute of Technology, Zurich, Switzerland.
Coffee, 14:50
The 17th Symposium on Measuring Techniques in Transonic and Supersonic Flow in Cascades and Turbomachines
STOCKHOLM – SWEDEN
9 & 10 SEPTEMBER 2004
Session 7 – Measurement Methodologies 2
Friday 10 September, 15:20 – 16:35
Session chair: ?
Paper 7-1: “FORCED RESPONSE MEASUREMENTS USING SLIPRING TECHNIQUE COMBINED WITH PREAMPLIFYING ELECTRONICS FOR DATA TRANSMISSION”
Hennings, H.
Institute of Aeroelasticity, German Aerospace Center, Göttingen, Germany.
Paper 7-2: “SHAFT POWER MEASUREMENTS IN A TRANSIENT TURBINE TEST FACILITY”
Atkins, N.; Ainsworth, R.
Department of Engineering Science, University of Oxford, UK.
Paper 7-3 “A NEW EXPERIMENTAL TECHNIQUE FOR MEASUREMENT OF THE STEADY-STATE METAL TEMPERATURE DISTRIBUTIONS OF FILM-COOLED NGVs”
Povey, T.; Jones, T. V.; Oldfield, M. L. G.
Department of Engineering Science, University of Oxford, UK.
Final Discussions and Close, 16:35