Setting Turnigy 9X/XR (Firmware ER9x) To work with Arkbird OSD
Attention!
The settings below are valid under the following conditions:
- All OSD module connection and your receiver are produced according to the instructions Arkbird OSD (ie 5th and 6th receiver channels connected respectively to the 5th and 6th inputs on the module OSD, as indicated in the instructions «RX AUX 5 »and« RX AUX 6 ")
- To control will use the toggle GEAR and FE LND (Fig. 1)
- Toggle GEAR and FE LND (three-way) on your transmitter has not tripped.
- 5th and 6th channels are not used.
- With firmware ER9x you are already a little bit, make friends :).
Figure 1
If the conditions are met, then turn on the transmitter and go to the menu «MIXER», select «CH5» and holding down the «MENU» call display mixer settings for the 5 th of the channel (Fig. 2)
Describe in detail how to create a mixer, I think it makes no sense. When questions arose, chickpeas - turn to the manual on ER9x.
Figure 2
All settings that are not included in the screenshot are the default.
This setting, we appointed to manage the switch GEAR MANUAL MODE. That is in position toggle switch "from themselves" mode is MANUAL MODE, and set to "ON themselves" we include tea one of three modes: Return To Home , Option Mode (Aka CUSTOM MODE) or Balance Mode. For to which of the three modes will be enabled to meet the three-positionSwitch F-E LND (Fig. 1)
To assign each of the three modes corresponding to the position of the toggle switch (Fig. 1), Created
give three mixer for the 6th channel. (To add to the mixer channel, which already have a mixer, you need toUP and DOWN keys to select an underscore cursor to the desired channel and press and hold the MENU button for 1-2 seconds. For details, see the instructions in the firmware ER9x).
Mixer mode "Return To Home"Looks like (Fig. 3):
Figure 3
Mixer mode "Option Mode"Looks like (Fig. 4):
Figure 4
Mixer mode "Balance Mode"Looks like this:
Figure 5
Thus, the menu «MIXER» would look like this (Fig. 6):
Figure 6
If you want to swap modes on the three-position switch, then just change the parameter «SWITCH» in each row on the right, while taking into account that:
ID0 - this position «N» three-position switch on the ID1 - the "1"
ID2 - position "2"
1st row in the channel 6 - is a mode Return To Home 2nd row - Option Mode
3rd row - Balance Mode
The transmitter is now ready to use and administer Arkbird OSD.
Important!
Do not forget to set the FailSafe mode on the receiver in such a way as to lose the signal transmitter comprises a series Mode «Return To Home»!
In this example, the firmware ER9x - r773, in other versions of the names of some of the menus and options can olichatsya can be added to the new settings.
**Translated from Russian original for the benefit of English speaking people by JBW, NZ. Full credit to original Russian creator of this document.