Power Saver User’s Manual
Product Brief Introduction
By using weak-strong current complementation and reactive power compensation and Germany high technology, the product saves your power bill by stabilizing the power, improving the power factor and reducing the power wasting from the whole system. It’s green energy efficient product which brings good energy saving for houses and other single phase applications.
The product is stable which has been well tested by technician before delivery and also, it has been proved as a good energy saving product from the long testing in the market. You will get different positive saving efficiency according to the application conditions of the loads and the systems.
Percolate transient wave peak Stabilize Current
Power saver Electric equipment
Single-phase diagram
Principle of reactive power compensation
The product reduces the amount of power drawn from the utility by storing (in its capacitors) otherwise lost and wasted electricity (watts) caused by the inductive appliances in your home or factory. The technology is applied by the power saver that stores electricity for your inductive loads, thus causing you to decrease your power bill demand from the utility. The logic is, you’ve already paid for the power bill, then you have no need to pay more for the wasted electricity. so, you can store it and reuse it again for the electricity system. The whole procedure is called power factor optimization. Think of it as simply recycling wasted electricity power that you paid and then were sent to the ground – wasted electricity, wasted fossil fuels and wasted YOUR MONEY!
Features:
1. No need electric circuit refitting, easy installation.
2. Small in size, low cost, plug in and play.
3. Reactive power compensation on the spot, improves power factor.
4. Reduces resistance in the circuit.
5. Reduces the abnormal heat for electric equipment.
6. Protects device from overloading and under voltage situation.
7. Protects device in transient peak voltage situation.
8. Prolongs the working time of devices by more than 30%, low down the repairing cost.
9. Wide use range for all inductive electric devices.
10. Made with high quality components, up to 2-5 years working life.
11. Fancy design, stainless.
220V installation for home using type
- Home using type
If the application is at home or for small shop with 220V power, please plug the power saver into available socket, when the indication light is on, that means it is working. If connect it close to your heavy loads, you will get better saving performance. If using it in rural building, connect it on the floor which is with most appliances or nearby your ammeter.
2. Note
220V using power saver installation sketch map
Pre-use notice
1. Check outlook if any broken outside.
2. Shake and check if any sound inside.
3. Check wire if in good condition.
In-use notice
1. While using, please don’t pull it out from socket, please keep it in working to make sure the performance. After pulling it out, please don’t touch the socket of power saver in 30 seconds. Or you may get an electric shock.
2. Please keep it away from children.
3. Don’t pull the lead-out wire of power saver vigorously.
4. If the power saver isn’t working, please change the fuse before you use it again.
Thanks for your using of our power savers!!!