oneM2M-ARC-2013-0532R01-3GPP-DeviceTrigger /
CHANGE REQUEST
Group Name:* / WG2
Source:* / NEC; KDDI
Format:* / TP8
Date:* / 2013-11-29
Contact:* / Tetsuo Inoue () ; Takanori Iwai ( ); JaeSeung Song JaeSeung.Song () ; Nick Yamasaki(); Masaharu Hattori ()
Reason for Change/s:* / Adding 3GPP Rel-11 Device Trigger over view and three more use cases in oneM2M architecture
Clause/Sub Clause
Affected* / 8.3
Agenda Item:* / Contribution
Work item(s):
Document(s)
Impacted* / oneM2M-TS 0001 Technical Architecture v 0 2 2
Intended purpose of
document:* / Decision
Discussion
Information
Other <specify>
Decision requested or recommendation:* / Agree to incorporate this into the TS (oneM2M-TS-0001)

oneM2M Notice

The document to which this cover statement is attached is submitted to oneM2M. Participation in, or attendance at, any activity of oneM2M, constitutes acceptance of and agreement to be bound by terms of the Working Procedures and the Partnership Agreement, including the Intellectual Property Rights (IPR) Principles Governing oneM2M Work found in Annex 1 of the Partnership Agreement.

  1. Discussion

Introduction:

Acontribution oneM2M-ARC-2013-0533-Device-Triggering-Overview described the necessity, the outline, and two Use Cases of Device Trigger.

AnothercontributiononeM2M-ARC-2013-0531-M2M-Service-Bootstrapping-Overview which is described thenecessity and outline of M2M Service Bootstrapping procedures.

This contribution arranges what is made inprovidesM2M procedure for the Device Trigger concretely as defined by the 3GPP Rel-11, three more Use Cases of Device Trigger for establishing IP connection in another viewpoint from Bootstrapping, and enabling M2M communication.are described

Possible features by 3GPP Rel-11 Device Trigger:

It is possible to send a Device Trigger request from IN-CSE to 3GPP MTC-IWF through the Mcn reference point (Tsp reference point in 3GPP) by 3GPP Rel-11 Device Trigger mechanism, as added to Annex B by the meeting last time.

The following information as defined by 3GPP (TS 29.368) may be provided in the device action request:can be included in this request as shown in Annex B.

-3GPP External Identifier or MSISDN,

-ASNIN-CSE Identifier,

-trigger reference number,

-validity period,

-priority,

-Application Port ID,

-trigger payload

A Device Trigger request signal is transmitted to SMS-SC within 3GPP network, distributed to a target device via SM Router etc. as a Short Message signal.

Since a protocol identifier called Device Trigger Short Message is set into the Short Message signal at this time, in receiving sides, such as SM Router and the target SM entity, validity of the requesting entity and/or the signal itself, etc. can also be checked and refused ignited by reception of this indicator.

Trigger payload can be set to a Device Trigger request signal as an option. Although reconfirmation is required to 3GPP expert, mThe maximum of the payload is of 200 octets could be set in the payload. (Refer to 3GPP TS 29.338 for SM-RP-UI)

That is, if triggere payload is used wellcould be used to transfer additional , Small data to the devicetransfer belowof the certain size is possiblethe maximum allowed size(200 octets) by 3GPP Rel-11. The payload can contain Furthermore, by setting up the access information (FQDN or IP address) to of the IN/MN-CSE or 3rd party entity, which allows into the payload and to makcreating the IP connectivity e between the M2M device ASN/MN-CSE accesses toand the IN/MN-CSE or 3rd party entity, it is a method different from the M2M Service Bootstrap procedure, and is also possible to create an IP connection between M2M device and M2M System according to the Device Trigger request from M2M System.

Therefore, there are 3 cases foreseen for Device Triggering:

  • sending additional data in the payload;
  • sending access information about IN/MN-CSE in the payload;
  • sending access information about a 3rd party entity M2M communication is attained not only by Small data but by Large data or data of the uploading direction from M2M devicein the payload.

Another advantage of the Device Trigger request using the 3GPP Tsp reference point is to provide a mechanism to reach M2M devices and to provide additional functionality for future release of 3GPP. The MTC-IWF is the dedicated connection point for M2M Systems to 3GPP mobile networks.

becoming a hub of M2M System focusing on MTC-IWF by the 3GPP side, and it is also mentioned that it can be surmised that future extension is easy.

2.Proposal

It proposes adding all (or discussing the part) the texts of “Possible features by 3GPP Rel-11 Device Trigger” in Discussion part mentioned above, and as Use Case of Device Trigger, the following three General Flows and the outline explanations into the Section 8.3 Mcn Reference Point.

Use Case-1 Device Triggering with Smallwith additional Data

This Use Case describes the scenario where the device triggering request is a case which includes Small additional dData in the Payload (limited to the maximum allowed by 3GPP) as an option of Device Triggering.

The maximum sizes of the Payload is 200 octets (confirmation to 3GPP expert is necessary) per a Trigger.

Step-1 It isis the device triggering request with the additional a transmitting request of Small Data toward ASN/MN-CSE from AE to IN-CSE.

Step-2 Determination of the transmitting method of the data in IN-CSE, selection of NSE, etc. is carried out. ACK is returned to AE if needed.

Step-3 2 Small Additional Data transmission by Device Trigger is requested.

Step-34Device Trigger is enforced by NSE. (It is Out-of-scope on oneM2M.)

Step-45The report of Device Trigger is reportedrequest is sent to from NSE to IN-CSE.

Step-56The report of the Data transmitting report is replied tomay be sent to the AE from IN-CSE.

Note-1) Although the further discussion is required, it depends on service provider policy if implicit or explicit device triggering is used.as one of options whether to specify the data transfer by Device Trigger explicitly from application, or to consider it as implicit enforcement.

Use Case-2 Device Triggering with access information about IN/MN-CSELarge Data

This Use Case provides a scenario where the payload is a case which includes Access information to about IN/MN-CSE (FQDN or IP address information) in the Payload as an option of Device Triggering.

ASN/MN-CSE which received this Device Trigger signal would access to the specified IN-CSE, and receive Large Data from IN-CSE after creation of an IP connection.

Step-1 It is a transmitting request of Large Data toward ASN/MN-CSE from AE to IN-CSE.

Step-2 Determination of the transmitting method of the data in IN-CSE, selection of NSE, etc. is carried out. ACK is returned to AE if needed.

Step-23 Transmission of Access information tof IN-CSEby in the payload of Device Trigger is requested from IN-CSE to NSE.At this time, wWhen IN-CSE received Large the Data from AE at from step-1, the data is kept on IN-CSE.

Step-34Device Trigger is enforced by NSE. (It is Out-of-scope on oneM2M.)

Step-45The report of Device Trigger request is sent to IN-CSE.Device Trigger is reported from NSE to IN-CSE.

Step-56Access via an IP connection is setup betweento IN-CSE from and ASN/MN-CSE. Then, Large Data kept by Step-3 is transmitted to ASN/MN-CSE from IN-CSE via the IP connection.

Step-7 6 Data transmitting report is replied sent to AE from IN-CSE.

Step-8 6 The data is transmitted from the IN-CSE to the ASN/MN-CSE is directly accessed from AE and Large Data is transmitted.

Step 7 The report of sending data to the AE

(Option) (Note-2)

Note-1) Although the further discussion is required, it depends on service provider policy if implicit or explicit device triggering is used.Although the further discussion is required, it depends on service provider policy as one of options whether to specify the data transfer by Device Trigger explicitly from application, or to consider it as implicit enforcement.

Note-2) When Large Data is not transmitted to IN-CSE from AE by Step-1, as the IP address information of ASN/MN-CSE which IN-CSE could know by the IP connection from ASN/MN-CSE by Step-6 is kept, IN-CSE may include this as an information element of Step-7.

Use Case-3 Device Triggering withaccess information about a 3rd party entityServer Access Request

This Use Case provides a scenario where the payload includes Access information about 3rd Party entityis a case which includes Access information to AE (FQDN or IP address information) in the Payload as an option of Device Triggering.

ASN/MN-CSE which received this Device Trigger signal would access to the specifiedAE3rd party entity, and send/receive Any Data to/from AE after creation of an IP connection according to the requests from AE.

Step-1 It is a transmitting request of Access information to AE of 3rd party entity toward ASN/MN-CSE from AE to IN-CSE.

Step-2 Determination of the transmitting method of the data in IN-CSE, selection of NSE, etc. is carried out. ACK is returned to AE if needed.

Step-3 2 Transmission of Access information to of AE 3rd party entity in theby Device Trigger is requested from IN-CSE to NSE.

Step-34Device Trigger is enforced by NSE. (It is Out-of-scope on oneM2M.)

Step-45The report of Device Trigger request is sent to IN-CSEDevice Trigger is reported from NSE to IN-CSE.

Step-56 Data transmitting report is replied to AE IN-CSE from IN-CNSE.

Step-6 Data transmitting report is replied to AE from IN-CSE.

Step-7 7 Access via anSetup IP connection to between AE from ASN/MN-CSE and 3rd party entity.

Step 8Then, ASN/MN-CSE send/receive Any Data to/from AE via the IP connection by requested from AESending/receiving data to/from 3rd party entity.

  1. Proposal

The proposal is to add:

The text in Possible features by 3GPP Rel-11 Device Trigger, Use Case-1 Device Triggering with additional Data, Use Case-2 Device Triggering with access information about IN/MN-CSE and Use Case-3 Device Triggering with access information about a 3rd party entity in section 8.3.2.1.1 Device Triggering for 3GPP (as proposed in contribution 0533R01).

Note: However the above-mentioned texts, when incorporated into the Section 8.3, delete the red font + yellow marker portion.

© 2013 oneM2M Partners Page 1 (of8)