Non-Conventional Energy Resource System Through Elevator to Power Ac Cfl Load Lamps

Mps17

NON-CONVENTIONAL ENERGY RESOURCE SYSTEM THROUGH ELEVATOR TO POWER AC CFL LOAD LAMPS

Technical Specifications:

Title of the project: Non-conventional energy resource system through elevator to power AC CFL Load lamps"

Domain: Renewable Energy Management, Energy systems,

Embedded Systems

Software:Embedded C, Keil, Proload

Power Supply :5V, 750mA Regulated Power Supply

Lead Acid Battery:12V, 1.3Ah

Inverter:12V (Input)/230V (Output)

DC Motor:3 Motors (3Volts)

Applications:Shopping malls, Airports etc.,

Developed By :M/S Wine Yard Technologies

Phone:040-6464 6363,

ABSTRACT

Energy is a major input for overall socio-economic development ofany society. From olden days we re using non renewable sources of energy in excess mount for our needs. As this type of minerals like coal etc. are exhausting so we have to depend on the renewable sources of energy like solar, wind, etc. For smaller application it is better to use renewable energy.

As this project is based on gravitational force and required AC supply. So for this particular application we are using Elevator arrangement which uses DC motor to charge the DC battery and the power from the battery can be used for this application. This project is designed by using an Elevator arrangement which is connected to the dc motor such that its output is given to theDC rechargeable battery.

Depending upon the movement of the Elevator the DC motor rotates and which will converts the mechanical energy to electrical energy which is given as an input supply to the 12V DC rechargeable battery. The o/p of this lead acid battery is given as input to the inverter which drives the AC loads. The battery is connected to the inverter. This inverter is used to convert the 12 Volt D.C to the 230 Volt A.C. This 230 Volt A.C voltage is used to activate the loads.

The output of DC Motor is given to 12V 1.3 Amp-Hour Lead-acid Battery. The battery is connected to the inverter which is used to convert the D.C 12 Volt to the 230 Volt A.C. By increasing the capacity of battery and inverter circuit, the power rating is increased.

This project uses regulated 5V, 500mA power supply. 7805 three terminal voltage regulator is used for voltage regulation. Bridge type full wave rectifier is used to rectify the ac out put of Lead-acid Battery.

Block Diagram:

Power Supply Unit: