ITS-IFToMM 2017 & K-TIS 2017

March 19-22, 2017, Jeju, Korea

Manuscript Template forITS-IFToMM 2017 & K-TIS 2017 Extended Abstract

Gildong Hong*#,Chulsoo Kim** and Young-HeeChoi**

*Department of Mechanical Engineering,Tribology NationalUniversity,Seoul, Korea

**Tribology Group, Korean Institute of Tribology,Daejeon, Korea

# Corresponding author:

ITS-IFToMM 2017 & K-TIS 2017

March 19-22, 2017, Jeju, Korea

1. Introduction

The format of the 1 or 2-page Extended Abstract for ITS-IFToMM 2017 andK-TIS 2017 should follow this template. This document is a guideline for the preparation of the Extended Abstract.

2. Results and Discussion

Times New Roman font should be used for the entire abstract. The title should be in font size 14pt, boldface and centered. Be sure to include the email address for the corresponding author.All margins, left, right, top and bottom, should be 25mm. The maximum length of the abstract is 2 pages in A4 size.

The section headings should be type in 9pt and boldface. The first word of the heading and all major words must start with a capital.Subsections are not recommended considering the limited number of pages.

The main text should be written in two 80 mm-wide columns with a 10 mm gap between the columns. The text should be in 8pt with single spaced. Paragraphs should be indented by 5 mm.

SI units should be used. Equations should be numbered consecutively and located at the right margin as in Eq. (1).

A = B x C + (x – z) (1)

Figures and tables should be placed at the top or bottom of either column as in Table 1 and Fig. 1.

Table 1.Table caption must be centered

Fig. 1. Figure caption must be centered.

3. Conclusions

References should be listed at the end of the abstract and arranged in order. References should be cited in the main text by numerals in a square bracket [1-3]. The format of the reference should follow the examples given in this template.

For all presentations, the Extended Abstract must besubmitted through the symposium website ( deadline for the Extended Abstract is September 15, 2016.

The acceptance (and revision) notice will be given by November 15, 2016. The accepted Extended Abstracts will be included in the conference proceedings provided that at least one of the authors registers to present the paper in the symposium.

Authors may also submit a Full Paper for consideration for publicationin participating journals. The papers will go through a peer reviewprocess according to the guidelines of the selected journal.

For other information, please refer to the symposium website at

Acknowledgment

Acknowledgment may be indicated here.

References

[1]C. S. Kim, K. S. Hong, and M. K. Kim, Nonlinear robust control of a hydraulic elevator, ASME J. Tribol., 13 (6) (2005) 789-803.

[2]R. S. Chandel and S. R. Bala, Effect of welding parameters and groove angle on the soundness of root beads deposited by the SAW process, Proc. of Trends in Welding Research, Gatlinburg, Tennessee, USA (1986) 479-385.

[3]S. Kalpakjian and S. R. Schmid, Manufacturing Processes for Engineering Materials, Second Ed. Addison-Wesley Publishing Company, New York, USA, (1992).

[4]A. C.Smith, Lubrication Mechanism, U.S. Patent 9876543 (1990).