Hypermax Engineering Inc Wire RingCylinder head Gasket Installation Procedure
Ford 6.0 L Powerstroke
Contents:
2 Gasket Bodies
8 Wire Combustion Rings
1. Remove the cylinder heads per service manual
2. Order new cylinder head bolts (This is necessary due to the “Torque to Yield” bolts)
3. Clean cylinder head surface and examine for any surface imperfections and determine if the cylinder heads must be resurfaced and/or a valve job done.
4. Clean and assemble the cylinder heads
5. Clean crankcase deck surface and inspect for any surface imperfections
6. Install cylinder head gasket body on to crankcase deck surface, be sure it lays flat. Slight “Bending”of the gasket body may be needed to retain the rings
7. Coat the wire combustion rings in it’s entirelywith clean anti-seize
8. Place the rings on to the crankcase surface (The gasket body will retain them)
9. Carefully place the clean cylinder head onto the crankcase, be sure not to damage the rings by dropping the cylinder head on them. The cylinder head must evenly contact the rings from the front cylinder to the rear cylinder. If not, the cylinder head must be removed to ensure that the rings are in place.
10. Torque the cylinder head per the service manual or to enclosed figure A. New bolts are a must to ensure proper sealing performance
Note: The use of new factory cylinder head bolts is needed to ensure the ultimate performance of this gasket system. The performance of “Cylinder Head Studs” has not been evaluated or required with this application. Failure to follow these recommendations may result in a cylinder head gasket failure. The use of “Cylinder head Studs” is done so at your own risk.
DISCLAIMER OF LIABILITY
Under no circumstances will Hypermax or their affiliates have any liability with respect to any claims or damages (whether direct or indirect, special, incidental, consequential or punitive) as a result of your access or use of (or inability to access or use) this Web site or its content, even if they have been advised of the possibility of such damages. You agree to access and use this Web site at your own risk.
This agreement sets forth the terms and conditions for the purchase and use of products purchased on this web site. The purchase of products from this web site indicates that the Buyer has read and understands this agreement and accepts the terms and conditions herein.
Hypermax Engineering Inc. and its dealers (hereafter Seller) shall be in no way responsible for the product's proper use and service. THE BUYER HEREBY WAIVES ALL LIABILITY CLAIMS.
The Buyer acknowledges that he is not relying on the Sellers skill or judgment to select or furnish goods suitable for any particular purpose and that there are no liabilities which extend beyond the description on the face hereof, and the Buyers hereby waivers all remedies or liabilities expressed or implied, arising by law or otherwise, (including without any obligation of the Seller with respect fitness, merchantability and consequential damages) or whether or not occasioned by the Seller's negligence.
The Seller disclaims any warranty and expressly disclaims any liability for personal injury or damages. The Buyer acknowledges and agrees that the disclaimer of any liability for personal injury is a material term for this agreement and the Buyer agrees to indemnify the Seller and to hold the seller harmless from any claim related to item of the equipment purchased. Under no circumstances will the Seller be liable for any damages or expenses by reason of use or sale of any such equipment.
The Seller assumes no liability regarding the improper installation or misapplication of its products. It is the installer's responsibility to check for proper installation and if in doubt contact the manufacturer.
Performance enhancing devices, if misused or utilized to excess, may cause a reduction in vehicle component life. Vehicle manufacturers may at their discretion, refuse to warranty failures allegedly caused by such devices. Refer to the warranty policy provided with your vehicle.
IN THE EVENT THAT THE BUYER IS NOT WILLING TO ACCEPT THE POSSIBLE CONSEQUENCES OF THIS AGREEMENT: THE BUYER MAY PROMPTLY RETURN PURCHASED PRODUCTS, IN A NEW AND UNUSED CONDITION.