Clean Water Investigation

Time: 30-60 minutes

Materials

Short, wide-mouthed clear plastic cups / Small metal paperclips / Plastic spoons / Plastic forks
Toothpicks / Liquid detergent / Funnels / Paper towels
#2 coffee filters / Gravel and sand / Soil (not potting soil) / Handouts

Introduction

We owe our lives to water. Without fresh, clean water to drink we can live for only a few days. You might think we are lucky, then, that 80 percent of the earth's surface is water. There should be plenty to keep us alive. But clean, drinkable water actually is a rare and precious thing. Consider: 97 percent of the water floating around the earth is the salt water of the oceans, leaving only 3 percent fresh, drinkable water. Of this fresh water, 2 percent is frozen in the ice caps. Only 1 percent is available for drinking.

Unfortunately, our fresh water supply is getting even smaller because of pollution. As the world gets more populated, more and more people are throwing more and more things into our limited supply of fresh water. Water forms a tight "skin" across its surface. This property is called surface tension. You can see surface tension when you pour a water glass really full and it bulges up over the rim without spilling over. The surface of clean water is so tight it can support lightweight things like water striders. You may have seen these inch-long bugs zipping across the surface of a fresh pond or stream. They have a hairy tail and their claws are located on the back of their legs. Their bodies don't break the water's surface. When water gets polluted with detergents and other chemicals, it loses its surface tension. Even a tiny amount changes water quality, so bugs like water striders are no longer supported. They step right through the surface and drown. One reason wetlands are so important is that they have the ability to filter and clean many kinds of pollution from water. Scientists are studying wetlands to learn about the ways they can help clean up pollution.

Directions

  1. Separate students into teams of 2. Before they begin, they should wash their hands. If hands are oily, the activity might not work.
  2. To make a pond, students should fill a cup with tap water to 1 cm below the brim.
  3. To make a water bug, they should bend up the inside tip of a paper clip to a 45 degree angle to make a tail. The rest of the paper clip should be kept flat. The outside end of the clip can be opened slightly (no more than 45 degrees for a more stable water bug).
  1. Students can use a fork to place their bug in the water, taking care not to break the water’s surface as they place the bug. The surface tension of the water should hold up the bug. It may take a little practice to get the bug to float, so if need be paperclips can be fished out of the water with a toothpick or a fork.
  2. Water bugs thrive in an environment of clean water, but what will happen when pollutants are introduced into the pond? Have the students predict what will happen to the water and bugs when campers arrive at the pond, decide to go for a swim, and wade in and stir up the muddy bottom.
  3. Students can test their predictions by stirring half a spoon of soil into the pond and trying to float their bugs.
  4. Ask students to predict what will happen when campers decide to wash their dishes in the pond. Idea: soap weakens the surface tension and makes it harder for the bugs to float.
  5. Students can test their predictions by floating their bugs, dipping a toothpick into a drop of liquid detergent, and introducing a tiny amount of soap into the pond.
  6. Now students will use different filtering materials to discover if they can remove pollutants from the water.
  7. Students should place a coffee filter in the funnel and predict what will happen to the water after it is filtered. They should use the handout to record their predictions and results.
  8. Students should pour about half of their polluted water from earlier through the funnel and filter, making sure to have a clean cup below the filter to catch the water.
  9. Now students should place a new coffee filter in the funnel and then place about 3 tablespoons each of gravel and sand in the filter. They can use the rest of their polluted water to test the new filter. Results should be recorded on the handout.

Discussion

How do you think dirt in the water might affect insects and fish in a real pond?

Under what conditions did the paper clip water bug float? Under what conditions did it sink?

How did you get the water bug to float again?