OFFICE OF TREASURY INSPECTOR GENERAL
FOR TAX ADMINISTRATION
DATE: July 1, 2010
Exhibit(400)-130.8
TIGTA Remington Armorer’s Maintenance Log Sheet
Remington Model 870 SN: ___________________ Division:_____________________ Page:__
TYPE: 18 inch bead sight 21 inch rifle sight 14 inch Scattergun Tech Modified
Assigned to Post of Duty (POD): ________________________________
Reason maintenance performed: Annual Inspection Other (If Other, explain below
and describe the specific complaint:)
________________________________________________________________________________________________________
Maintenance performed, action taken, and results:
________________________________________________________________________________________________________
Parts inspection completed: Yes No (See list below.)
Function test completed: Yes No (See Remington Armorer's training package.)
Test fired: Yes No
Cleaned: Yes No
Was a temporary firearm issued to the POD: Yes No
(If yes, provide model _____ and serial number:_____________________and dates:________to______)
Remarks:
________________________________________________________________________________________________________
----------------------------------------------------------------------------------------------------
Date Maintenance Completed: _____________ Armorer: ________________________
Date Armorer Certification Expires : ________
Test fired by: ________________________
Location:_______________________________________________________Date: ________
---------------------------------------------------------------------------------------------------------------------
Operations Manual 1 Chapter 400
OFFICE OF TREASURY INSPECTOR GENERAL
FOR TAX ADMINISTRATION
DATE: July 1, 2010
Parts Inspection: (Confirm serviceability by checking after you inspect each part/grouping.)
Operations Manual 1 Chapter 400
OFFICE OF TREASURY INSPECTOR GENERAL
FOR TAX ADMINISTRATION
DATE: April 1, 2005
Safety _____
Function Check:
Headspace _____
Function _____
Magazine cap _____
Barrel Assembly _____
Fore-end assembly _____
Bolt assembly _____
Slide assembly _____
Receiver Assembly _____
Magazine Spring, retainer
& follower ____
Shell latches: Left _____ Right ____
Trigger Plate Assembly
Stock Assembly
Overall Function
Finish and overall condition
of firearm. ___
Is the Firearm Serviceable:
Yes No
Front Sight _____
Rear Sight _____
Sling_____
Sight-in information/remarks: ___________________________________________________________________________________________________________________________________________________________________________________
Operations Manual 2 Chapter 400