Department of Revenue
Vehicle Specifications
Model: 2018 Ford F650 XLRegular Cab, 22’ Van Body Truck GVWR 26,000 lb.
In addition to the XL Package Standard Features, vehicle should include the following:
PAINT
Environmentally Friendly “3-Wet System”, color: Oxford White
POWERTRAIN/BRAKES
6.8L 3V SEFI V10 Gasoline Engine - 320 HP @ 3900RPM, Torque: 460 ft.-lbs. @ 3000RPM
6-Speed Automatic Transmission – Double Overdrive
2 Wheel Drive, Dual Rear Wheel
Hydraulic Brake System-Bosch HydroMax w/Traction Control
Air Dryer, Bendix AD/1P with Heater
8,500 lb. Cap Non-Driving Dana 850F
Taper-Leaf Springs, Parabollo-8,500 lb. Capacity
Front Stabilizer Bar
Lube, Front Axle, Emgard 50W, Synthetic Oil
17,500 lb. Single Speed, Dana S17-140
Multi-Leaf Springs, 19,000 lb. Capacity
Lube, Rear Axle, Emgard 75W-90, Synthetic Oil
6.50 Axle Ratio
EXTERIOR
242” Wheelbase, 168” CA, AF/381 OAL
Frame: Single Channel-Straight “C” 10.75 SM, 80,000 PSI
Single, Horizontal Muffler-Frame Mounted Right Side of Vehicle
Fuel Tank-LH 50 Gallon, Steel
Fuel Fill
Back Up Camera
Mirrors, Dual-Heated Rectangular, XL2020-96” Width
Bumper, Front, Black, Full Width
Painted Grille, Plastic
Tow Hooks, Front Two (2) each-Frame Mounted, Black
ELECTICAL
175 Amp Mitsubishi Alternator, Extra Heavy Duty 12 Volt
Two (2) each 900 CCA, 1800 Total, Battery, with Battery Box
Body Builder Wiring-at end of Frame, Separate
Daytime Running Lamps
Voltmeter
Lights-Roof Marker/Clearance-Amber Lenses, Five (5) each
Intelligent Oil Life Monitor
INTERIOR
Interior Color: Gray
30/70 Fixed Driver & Fixed 2-Passenger Bench Seat, Cloth
Black Vinyl Floor Covering
Steering Column, Tilt
Steering Wheel, Black PVC with Integral Cruise Control
Radio: AM/FM Stereo with Auxiliary Audio Input Jack & Clock
TIRES /WHEELS
Front: 22.5 x 7.5 White Powder Coated Steel Wheels
Front: Two (2) 11R22.5G Goodyear Endurance RSA Tires
Rear: 22.5 x 7.5 White Powder Coated Steel Wheels
Rear: Four (4) 11R22.5G Goodyear Endurance RSA Tires
Front Wheel Seals, Oil Lubricated, SKF ScotSeal
Rear Wheel Seals, Oil Lubricated, SKF ScotSeal
VAN BODY
22 ft. aluminum cargo van, 90 inch inside height, 92 inch inside width, aluminum or steel side and front posts, hat section type on 23-l/2” centers or Z section type on 16” centers, aluminum or steel rear corner posts, smooth acrylic white aluminum side and front panels, heavy duty aluminum lower rub rail, one-piece aluminum roof bonded to roof bows, interior sides and front lined full height with ¼ in plywood, varnished. Two rows of “E” track, one at 24” above the floor, the other at 48” above the floor, standard floor, 1-1/8” thick laminated shiplap hardwood, forklift package to include 24” threshold plate, two plastic covered dome lights with switch at rear, light in cab dash which activates when the body dome lights are on, plastic covered overhead door with heavy duty spring-load capable of being padlocked, 84”Hx87W (approximate) clearance with door in open position, all joints and seams thoroughly sealed with leakproof compounds, steps and grab handle at rear on right side and full width 6” rear dock bumper (not required if tailgate lift with dock bumpers is specified). All body lighting shall be LED.
LIFTGATE
2,500 lb. load capacity tailgate lift 72 in. x 36 in. platform with 6 in. ramp flush with ground in lowered position. 12-volt electric hydraulic power with power cut-off switch in the cab. Heavy duty switch - Metal splash guard to protect switch, motor and pump. Provision for locking controls. Dual controls for tailgate operation. Heavy duty dock bumpers, compatible with tailgate lift, installed on the tailgate lift dock extension, one (1) each side. Reference: Waltco Model C25 or approved equal.
1