Aqualink RS All Button Simulator Instructions

AquaLink RS All Button Simulator Instructions

To Operate the AquaLink RS Control Panel

Open the Alwin folder and from it open the Pwrcntr (Power Center) file. The Pwrcntr file is a simulation of the AquaLink RS Power Center Bezel and therefore must be open so the Controller can communicate.

Next open the AquaLink folder and from it open the file named Print (Control Panel). You can now program and operate the equipment. To open the OneTouch double click on Smallcp.

Note: Setup allows you to change the Controller color scheme, Delay Override allows you to cancel the safety delay in effect.

To change the model of AquaLink RS return to Power Center - Untitled and click on Model. The model menu will open. Click on the part number (these are part numbers for the PPDs) to high-light. When you return to the AquaLink control panel the buttons, and operation will change to the model you chose.

If you change the model to an RS 12, 16, 2/10 or 2/14 an auxiliary Power Center should also be opened. In the Alwin folder double click on Remaux (Remote Power Center).

To change how fast the simulator’s clock runs, for testing programs, you can click on Time Scaling at the Power Center - Untitled, the Set Time Scale Factor menu will open. Normal time is a Scale Factor of 1, changing the scale from 1 to 60 would increase the simulator Controller clock speed so 60 minutes of simulated time would pass in one minute of real time.

Note: it is very difficult to program equipment when the clock is running fast, return setting to 1 after testing.

Opening the file labeled Simio in the Alwin folder and you can change temperatures, set Dip Switches, operate the Spa Side Switch and change the battery voltage.

Opening the TeleLink and/or the 8button from the Alwin folder will allow you to simulate phone communication and the SpaLink (8 Button Remote) operation.

1

simulator.doc5/8/2006