1. Change Section Numbering When Used in Conjunction with Standard Specifications

02844B_D12-20-99

Page 2 of 2

Page 1 of 2

1. Change section numbering when used in conjunction with Standard Specifications.

2.__PARKING BUMPERS

2

PART 1.- GENERAL

3

Scope.-This work shall consist of furnishing and installing precast concrete parking bumpers in accordance with the details shown on the plans and these special provisions.

4

PART 2.- PRODUCTS

5

Parking bumpers.-

6

Parking bumpers shall be commercially available precast parking bumpers.

7

Parking bumpers shall be 1220mm long, nominal 200mm wide and 150mm high with both top longitudinal corners continuously chamfered, and anchor holes 230mm from each end.

8

PART 3.- EXECUTION

9

Layout.-Arrangement of parking bumpers shall be coordinated with the layout of parking stalls and traffic aisles, providing the proper angle to engage wheels and proper location to prevent overtravel of vehicles.

10

Parking bumpers shall be anchored with two 19mm diameter reinforcing bars 380mm in length. The reinforcing bars shall be installed such that the top of the bars is flush with the top of the parking bumper.