GWG-30/40 - Hardware Specification, document revisionC;
GWG-40 Wireless Interfaces –4G WWAN (Cinterion PLS8-E)LTE / 800/900/1800/2600 MHz
Transfer rate (max): 100 Mbps down, 50 Mbps up
UMTS/HSPA+/DC-HSPA+ / 900/1800/2100 MHz
Transfer rate (max): 42 Mbps down, 5.76 Mbps up
GSM/GPRS/EDGE / 900/1800 MHz
Transfer rate (max): 236.8 Kbps down, 236.8 Kbps up
GSM Connectors / 1 or 2 x 50 Ω SMA (Center pin: female)
SIM Slots / 1
GWG-30 Wireless Interfaces –3G WWAN (Cinterion PHS8-E)
UMTS/HSPA+ / 900/2100 MHz
Transfer rate (max): 14.4 Mbps down, 5.76 Mbps up
GSM/GPRS/EDGE / 900/1800 MHz
Transfer rate (max): 384 Kbps down, 384 Kbps up
GSM Connectors / 1 or 2 x 50 Ω SMA (Center pin: female)
SIM Slots / 1
Wireless Interfaces –GNSS (Cinterion PLS8-E/PHS8-E)
GNSS Systems / GPS, GLONASS
GNSS Tracking Sensitivity / -159 dBm
GNSS Acquisition Sensitivity / -149 dBm
GNSS Cold Start Sensitivity / -145 dBm
GNSS Cold Start / <32 seconds TTFF @ -130 dBm
GNSS Connector / 1 x 50 Ω SMA (Center pin: female)
Wired Interfaces – RS232
Ports / 1
Standard / EIA/TIA-232, RS-232, V.28/ V.24
Data Rate / 400 kbps
DTE/DCE / DCE
Signal Support / TXD, RXD, CTS, RTS
Flow Control / Software XON/XOFF, Hardware CTS/RTS
Connector / D-SUB 9, female
Pinout / 2: TX, 3: RX, 5: GND, 7: CTS, 8: RTS, remaining pins: NC
Wired Interfaces – RS-485/RS-422
Ports / 1
Standard / RS-485/RS-422, 4 wires, Full-Duplex
Data Rate / 10 Mbps
On-Board Termination / None
Connector / Phoenix 1844249
Pinout / 1: RX+, 2: RX-, 3: TX-, 4: TX+, 5: GND
Wired Interfaces – USB
Ports / 1
Standard / USB 2.0 Device
Signaling / Full Speed, High Speed
Connector / USB mini AB
Wired Interfaces – Ethernet
Ports / 1
Standard/Physical Layer / IEEE 802.3; 10/100 Base-T
Data Rate/Mode/Interface / 10/100 Mbit/s; Full or Half duplex; Auto MDI/MDIX
Connector / RJ-45
Wired Interfaces – Digital Input/Output (available on GPIO Connector)
Digital Inputs/Outputs / 3 user selectable input or output
Digital Inputs / with internal weak pull-up, active when pulled down to GND
Digital Outputs / open-drain, 4-28V, no over-current protection
Connector / Phoenix 1844249
Pinout / 1: +5VDC with 500mA resettable PTC fuse, 2: IO1, 3: IO2, 4: IO3, 5: GND
Wired Interfaces – Digital Input/Output (available on Power Connector)
Digital Inputs/Outputs / 1 output, 1 ignition sense input
Digital Output / open-drain, 4-28V, 350 mA ressetable PTC fuse
Ignition Sense Input / active when pulled up to 9-36 VDC
Connector / Molex 43045-0400
Pinout / 1: +9..36VDC (also Analog Input), 2: GND, 3: Ignition Sense Input, 4: Digital Output
Wired Interfaces – Analog Input (available on Power Connector)
Analog Input Range / 9-36 VDC
Pinout / 1: +9..36 VDC (also Analog Input), 2: GND, 3: Ignition Sense Input, 4: Digital Output
Power
Input / 9-36 VDC
Input Protection / Reverse polarity, transients, overcurrent (internal 2 A resettable PTC fuse)
Consumption at 12 VDC / Hibernation (GPS OFF, GSM OFF): TBD mA
Sleep (GPS OFF, GSM wake-up on SMS or call): TBD mA
Typical (GPS ON, GSM ON): 150 mA
Peak (GPS ON, GSM TX burst for 577 s every 4.615 ms): 1 A
Connector / Molex 43045-0400
Pinout / 1: +9..36VDC (also Analog Input), 2: GND, 3: Ignition Sense Input, 4: Digital Output
Physical
Dimensions (L x W x H) / 101mm x 88mm x 30mm
(connectors and rubber stands included)
Weight / 248g
Status LEDs / Power, Signal, Network, LAN (on Ethernet connector: Link, Activity)
Pushbuttons / 1 – Device Reset (short press)/Factory Default (long press)
Material / Steel sheet 0.8 mm
Mounting / desktop, wall, or DIN rail (DIN rail mounting kit sold separately)
Environmental
Operating Temperature / -20° C to +70° C
Storage Temperature / -40° C to +85° C
Relative Humidity / 5% to 95% (non-condensing)
IP rating / IP40
Ethernet Isolation / 1.5 kV RMS
RS-485 Port Protection (ESD) / 2 kV
Approvals
GSM/UMTS / TBD
Emissions/Immunity, Materials / CE, RoHS,TBD
Accessories (included)
Power supply cable / Cable length: 1.2 m
Cable connector: Molex 43025-0400
Wires: 4 wires, stranded, AWG-22
Pinout: 1 (red) POWER, 2 (black) GND, 3 (white) IGNITION, 4 (green) GPIO OUT
3G GSM antenna / Frequency: 850/900/1800/1900/2100 MHz
VSWR: ≤2.0
Gain: 4.5dBi
Connector: SMA (Center pin: male)
Dimensions (L x W x H): 163 mm x 22 mm x 14 mm
Accessories (optional)
AC/DC adapter / Input: 90-264 VAC, 47-63 Hz
Output: 12 VDC, 2 A
GSM antenna extension cable with magnetic base / Cable length: 3 m
Cable connector: SMA (Center pin: male)
Magnet base connector: SMA (Center pin: female)
Magnet base dimensions (D x H): 50 mm x 40 mm
Active uBlox GPS antenna with magnetic base / Cable length:5 m
Cable connector: SMA (Center pin: male)
Frequency: 1575 ± 3 MHz
LNA Gain: 27 db
VSWR: max. 2
Dimensions (L x W x H): 48 mm x 40 mm x 13 mm
DIN rail mounting kit / DIN rail clip with 3 screws