Display Schematics

Head-Up Display Inoperative

Step / Action / Yes / No
Schematic Reference:
1 / Did you perform the Diagnostic System Check - Vehicle? / Go to Step2 / Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2 /
  1. Turn the ignition OFF.
  2. Move the head-up display (HUD) dimmer switch to the full bright position.
  3. Turn ON the ignition, with the engine OFF.
Do all segments of the head-up display illuminate for 3.5seconds? / Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems / Go to Step3
3 / Does the HUD display 2dashes? / Go to Step4 / Go to Step5
4 / Test the HUD clock circuit for a short to ground, or an open at the instrument panel cluster (IPC).
Did you find and correct the condition? / Go to Step18 / Go to Step6
5 / Test the HUD ground circuit for a short to B+, or an open at the IPC.
Did you find and correct the condition? / Go to Step18 / Go to Step8
6 / Test the HUD data circuit for an open or a short to ground at the IPC.
Did you find and correct the condition? / Go to Step18 / Go to Step7
7 / Test the HUD strobe circuit for an open or a short to ground at the IPC.
Did you find and correct the condition? / Go to Step18 / Go to Step13
8 / Test the HUD ignition1 circuit for a short to ground, or an open at the IPC.
Did you find and correct the condition? / Go to Step18 / Go to Step9
9 / Test the HUD dim slider circuit for an open at the IPC.
Did you find and correct the condition? / Go to Step18 / Go to Step10
10 / Test the HUD switch ground circuit for an open at the HUD switch.
Did you find and correct the condition? / Go to Step18 / Go to Step11
11 / Test the HUD switch dim slider circuit for an open at the HUD switch.
Did you find and correct the condition? / Go to Step18 / Go to Step12
12 / Test the HUD switch page circuit for an open at the HUD switch.
Did you find and correct the condition? / Go to Step18 / Go to Step13
13 / Inspect for poor connections at the harness connector of the HUD switch and IPC.
Did you find and correct the condition? / Go to Step18 / Go to Step14
14 / Inspect for poor connections at the harness connector of the HUD.
Did you find and correct the condition? / Go to Step18 / Go to Step15
15 / Replace the HUD switch.
Did you find and correct the condition? / Go to Step18 / Go to Step16
16 / Replace the HUD.
Did you find and correct the condition? / Go to Step18 / Go to Step17
17 / Replace the IPC.
Did you complete the replacement? / Go to Step18 / --
18 / Operate the system in order to verify the repair.
Did you correct the condition? / System OK / Go to Step2

Front Floor Console Replacement

Removal Procedure


  1. Apply the park brake.
  2. Remove the floor console bolts from the sides of the console. Adjust the front seats as required.
  3. Shift the transaxle to 2.
  4. Remove the screw from the shift handle. Remove the shift handle.
  5. Pull upward on the rear of the console assembly in order to release the two vertical fastening clips securing the console assembly to the floor bracket.
  6. Pull the floor console rearward slightly. Disconnect the electrical connector at the front of the floor console.
  7. Remove the floor console.
  8. Remove the wiring harness.
  9. Remove the HUD switch.

Switch Replacement

 Disconnect the electrical connector.

 Disengage the retainers.

 Press the switch from the bottom out the top of the floor console. Remove the head up display switch.