Engineering Toolmaking (Jig and Fixture Manufacture)

Engineering Toolmaking (Jig and Fixture Manufacture)

Level 3

Awarded by the EMTA Awards Limited
Accredited from 2 November 2005 to 30 November 2010
Group award number: G83D 23
Standards

This SVQ is based on standards developed by SEMTA. SEMTA draws its membership from the engineering sector.

For further information, please contact the SQA web site.

Structure of the SVQ

The way the SVQ is made up is shown below. The unit title appears in bold and the elements that make up each unit are listed under the unit title.

Mandatory units

Candidates must complete all of these units:

Complying with Statutory Regulations and Organisational Safety Requirements

1 Complying with statutory regulations and organisational safety requirements

Using and Interpreting Engineering Drawings and Documentation

1 Using and interpreting engineering drawings and documentation

Work Efficiently and Effectively in Engineering

1 Work efficiently and effectively in engineering

Optional units

Candidates must also complete 3 of the following units, in addition to the mandatory units.

Producing Jig and Fixture Components Using Hand Fitting Techniques

1 Producing jig and fixture components using hand fitting techniques

Machining Components for Jigs and Fixtures

1 Machining components for jigs and fixtures

Fabricating Structural Components for Jigs and Fixtures

1 Fabricating structural components for jigs and fixtures

Assembling jigs and fixtures using a manual welding process

1 Assembling jigs and fixtures using a manual welding process

Carrying Out Repairs or Modifications to Jigs or Fixtures

1 Carrying out repairs or modifications to jigs or fixtures

Checking that Toolroom Assemblies Comply with Specification

1 Checking that toolroom assemblies comply with specification

There may be publications available to support this SVQ. For more information, please contact:

EMTA Awards Ltd (EAL)

National Verification Centre

3365 Century Way

Thorpe Park

Leeds

LS15 8ZB

Tel: 01132 601188

Fax: 01132 321159

Website: www.eal.org.uk

Engineering Toolmaking Jig and Fixture Manufacture/3/140905