Version 1.2

Thank you for purchasing PAMSPAN501x. Now you can take advantage of this new G.SHDSL.bis technology with high symmetric transmission rate.

The quick installation guide will help you to setup in minutes.

Package Contents:

PAMSPAN501x / RJ-11 Cable
Power Adapter / Support CD
RJ-45 Cable Q.I. / Quick Installation
Guide

Hardware Installation:

Step 1: / Connect the RJ11 cable supplied to the port marked DSL at the back of the PAMSPAN501X. Connect the other end of the cable to your SHDSL signal source.
Step 2: / Insert one end of the RJ45 Ethernet cable into one of the LAN ports on the back of the PAMSPAN501X. Connect the other end of the cable to the Ethernet Network Interface Card (NIC) in your PC. Up to four Ethernet devices can be connected to the PAMSPAN501X. Use a crossover cable when connecting a hub.
Step 3: / Connect an earth ground to the grounding terminal (marked FG).
Step 4: / Connect the external AC adapter supplied to the DC power outlet on the back of the PAMSPAN501X. Connect the power supply to your wall outlet or surge protector.

2.1 DSL Connectors Description

DSL Connectors on back of the unit, 2 RJ-11 sockets.

RJ-11 uses a 6P4C connector and cable. The cable has 4 wire and we are

using them for 2 pairs of DSL connection.

Pin 1: Not used.

Pin 2: Tip for DSL pair 2 or 4. Pin 3: Tip for DSL pair 1 or 3.

Pin 4: Ring for DSL pair 1 or 3.

Pin 5: Ring for DSL pair 2 or 4

Pin 6: Not used.

Software Configuration

Users can login the system via Console, Telnet, CLI, or Web to execute advanced configuration.

3.1 LAN IP Configuration

3.1.1 Via EmWeb

1. From the Configuration menu, click on LAN connections. The following page is displayed and then click on .

2. Then type new primary address detail as follow:

3. Click on to submit your setting.

3.1.2 Via CLI and Telnet

Command: ip set interface iplan ipaddress <IP>

3.2 SHDSL Port Configuration

Click on Shdsl from the Port Configuration menu. When Shdsl Port Configuration page is displayed, basic port settings are provided to configure, shown as follows:

Click on to submit your setting or to clear your setting.

3.2.1 1/2/4/8 Wire Mode configuration

3.2.1.1 Via EmWeb

Click on Wire Mode drop-down list to select the Wire Pair number needed.

Wire Pair / DSL Pair to Use / Illustration
2-Wire Mode / 1
4-Wire Mode / 1,2
6-Wire Mode / 1,2,3
8-Wire Mode / 1,2,3,4

3.2.1.2 Via CLI and telnet

Command: port shdsl set WirePair < ATM 1-pair/ ATM 2-pair / ATM 3-pair / ATM 4-pair >

3.2.2 CO/CPE Mode Selection

3.2.2.1 Via EmWeb

Click on Role drop-down list to set the device role as CO or CPE.

3.2.2.2 Via CLI and Telnet

Command: port shdsl set UnitID StuC/StuR>

3.2.3 Max/Min Line Rate Configuration

3.2.3.1 Via EmWeb

To set the device’s line rate, set the maximum and minimum line rate in the Max Line Rate and Min Line Rate fields respectively (192000bps to 5696000bps).

3.2.3.2 Via CLI

Command: port shdsl set <MaxLineRate/ MinLineRate> <value

Advanced Setting

For more detailed information about complete configuration, please refer to

the user manual on support CD.