Jansen Brandschutz

Telescopic sliding door ORPHEUS T90/EI90 2-leaf

  • Ideal for openings with small lateral space requirements in the setdown position.
  • Recess shutters provide invisible fire protection.
  • Installation of escape or postern doors possible.
  • Also available as a three-part telescopic sliding door.

Door leaf:

The telescope leaf consists of two or three offset in series current telescopic sliding elements. The telescopic sliding element consists of several 300 - 1100 mm wide elements (depending on the door width). The separate elements are joined to a sturdy door leaf through a special linking system so that no concavities, respectively screw heads are visible. The thickness of the door leaf is 62 mm. The surface is completely level and consists of zinc-coated, 0.75 mm thick steel sheets. The steel sheets and the fire protection filling are caulked all over. The running-in profile and the labyrinth profile are zinc-coated.

Guide rail:

Each door element is guided in ball bearing mounted castors. The cold-milled, zinc-coated C-profiles are mounted to the ceiling by means of brackets. The guide rail casings are zinc-coated.

Floor guidance:

The floor guidance is located laterally of the clear width.

Equipment:

As fittings a C-shaped handle is used on the opposing wall, a shell-shaped handle on the wall side. The opening of the door is limited by end position dampeners which are mounted on consoles. The door closes automatically due to closing weights, while a constant closing speed is ensured by a hydraulic closing speed control. As a standard feature a free-run device enables the door to be handled easily under normal application conditions.

Control:

A specially coordinated control system (lock system) which has been approved by building control is employed, optionally with an opening aid.

Supplementary equipment:

Surface coating:Primer, colouring according to RAL, DB or NCS

Doors:Escape or postern door

Glazing:Round and square glazing

Electrical options:Impulse control, time closing, battery buffering

Control elements:Push button, key switch, pull switch, IR-/radar motion sensor, radio, induction loop, under-glass release button

Recess shutters: Vertical (180° hinged, up to a width of 1000 mm) and horizontal(90° hinged)

Safety equipment:Flash light, light barrier, bow latch look

Approved according to:

General technical approved with the number Z-6.20-2138 by the German Institute for Structural Engineering.