BLDC APPLICATION SPECIFICATION SHEET

COMPANY / CONTACT
ADDRESS / PART OR DRAWING NUMBER
ESTIMATED ANNUAL USAGE
PHONE / FAX / E-MAIL

Application

a. Customer application
b. What mechanism is the motor driving in the application?
c. ( New / Existing ) If existing, who is the current supplier? / Is unit available for test? / ( Yes No )
d. Are there any problems or concerns with the existing supplier’s motor?

Performance Requirements:

a. Rated Voltage / b. Voltage Range:
c. Output torque est. by / Select one / d. Start Torque / Select one / e. Run Torque / Select one
f. RPM at No Load / g. RPM at Load / h. Willgearmotor be stalled? / Yes No

Environment

a. Ambient temp. / b. Humidity level / c. Degree of Protection(IP)
d. Heatsinking? / e. Thermal resistance of heatsink / f. Autoclavable?
g. Anything else we should know about the location of our motor within the application?
Duty Cycle/Life / ( < 25% 25% 50% 75% Continuous Other ) / Define other
a. Standard duty cycle / ON Select one / OFFSelect one
b. Most demanding / ON Select one / OFF Select one
c. Minimum life required / in cycles / in hours / note: both required

Power Supply

a. Rated voltage: / b. Maximum current limit / c. Is the supply filtered? / ( Yes No )
d. Supply type: / ( Switched Mode Transformer, bridge, cap, linear regulator battery ) / Frequency: / kHz
Overhung Load ( Yes No ) / How much? / lbs. / Distance from mounting surface
Axial Thrust Load ( Yes No ) / How much? / lbs. / ( Push-in Pull-Out Both )

Output Shaft Requirements

a. Shaft OD / b. Direction of rotation / ( CW CCW ) / Viewed from / Cover Side / Motor side
c. Shaft Detail / Flat / Tongue / Woodruff Key / Hole / Keyway / Slot
d. Extension from mounting surface / Cover Side / Motor Side
Agency Requirements: UL CSA CE RoHS Other / If other, please list:
Sound / Vibration Requirements / Method of test
Gear Box SelectionSelect ratio from catalog list

EMI / RFI Considerations Emissions Type: ( Conducted Radiated Both )

Agency Requirements: UL CSA CE RoHS Other / If other, please list:

Feedback Requirements:Yes No

Encoder Hall Effect Optical / Channels 1 2 / Line Driver / Index Pulse / PPR

Motor Driver Requirements

  1. Motor driver (amplifier required)
( Yes No )
d. Is reverse direction required?
( Yes No ) /
  1. Type of Motor Speed Control Select one
e. Is integral electronics required?
( Yes No ) / c. Closed Loop Select one
f. Special Control Requirements
( Braking Soft Start Current Limit )

Mounting Position: Indicate orientation in your application as shown below: Select one

Send this in via email to :

M2254-0612