World’s Finest Automotive Bra Installation Instructions: C5 CorvetteShift Boot (6-speed manual transmission)
Tools required: small flat blade pocket screw driver, medium flat-blade screwdriver, needle-nose vise-grip pliers, side cutter, needle-nose pliers, tube super glue, ball peen hammer, center punch
Parts included: none
Pre Installation
1)Carefully read and follow instructions to ensure optimal performance
2)Find a comfortable, well-lighted place to work.
3)Find/create a safe place to temporarily stow each component you remove.
4)Use a plastic bag or other tray to temporarily stow the fasteners you remove.
5)Take your time.
SL Shift Boot Installation
1)Remove the shift knob.
a)Use the small pocket screw driver to pry out the shift diagram plate from the top of the shift knob.
b) Notice the metal pin in the recessed area in the top of the shift knob. Notice how the pin is oriented (before you remove it, so you can re-install it later).
c)Use the needle-nose vise grip to grab onto that metal pin to wiggle and pull upward to remove it.
d)Un-screw the shift knob from the shaft.
2)Remove the shift boot.
a)Notice the bottom of the shift boot is attached to a plastic collar and pressed down into the console.
b)Use your fingers to work around the bottom edge of the shift boot and pull-up the bottom edge of the shift boot (and collar). Work evenly because the collar will flex. Be careful not to break the collar because you will need to re-use it.
c)Remove the shift boot from the car.
3)Remove the stock shift boot from the plastic collar.
a)Notice the location of the seam on the plastic collar.
b)Mark the location of the seam on the collar with the grease pencil.
c)Use the small pocket screw driver and/or the needle-nose pliers and/or the side cutters to remove the staples holding the stock shift boot onto the plastic collar.
d)Notice the stock shift boot is also glued to the collar.
e)Break the glue seal.
f)Pull the stock shift boot from the collar.
4)Install the new SpeedLingerie Shift Boot.
a) You may use the super glue to glue the new shift boot to the plastic collar, just as the stock boot was attached.
b) Slip the SpeedLingerie Shift Boot and plastic collar over the shaft
c) Press the plastic collar back into the console.
5)Re-install the shift knob
a)Screw the shift knob back onto the shaft.
b)Re-insert and press the metal pin back into place.
c)Use the ball peen hammer and center punch to tap it into place, so it is secure.
d)Re-insert the shift diagram plate back into place.
Final Adjustment
1)For full effect of SpeedLingerie design and glove-like fit, allow 72 hours for material(s) to relax and conform.
2)Park in a warm sunny spot with the SpeedLingerie on for a few days, to help the process.
3)You may apply a quality vinyl conditioner if you so desire.
Care & Maintenance
1)For best results, be sure that vehicle surfaces are clean and dry before installing SpeedLingerie.
2)Clean outer vinyl surfaces of SpeedLingerie with a high quality conditioner during routine car maintenance.
Congratulations again on your SpeedLingeriepurchase.
Installation Questions? Call 1(800) 570-1579 for assistance.
Page1
rev 0503