Viper 791 XV Installation Guide for Tiburon
Remote Start
Remote Start Primary Harness (7 Wires)
(heavy gauge inline connector, key switch interface, relay satellite)
Viper ModuleCar
THE WHITE WIRES HAS TO BE CUT, GREEN WIRE WILL GO CONNECTED TO THE SIDE WHERE THE KEY GETS INSERTED, AND THE PURPLE WILL GO TO THE STARTER SIDE.
PURPLEWHITE (STARTER SIDE)
GREENWHITE (KEYSIDE
RED (2)RED (2) CONSTANT
ORAGNEPINK (+)
PINK/WHITEN/C
RED/WHITE N/C
PINKRED (+) IGNITION
HIGH VOLTAGE AND CURRENT RUN THROUGH THESE WIRES. MAKE SURE YOU SOLDER ALL OF THESE CONNECTIONS FOR PROPER CONNECTION, AND TO ELIMINATE ELECTRICAL FIRE.
Harness # H3
Viper 791 XV Installation Guide for Tiburon
Remote Start
Tachometer….VIOLET/WHITE (viper) to the WHITE (car) wire on passenger side kick panel (23 PIN CONNECTOR)
Brake (Auto Transmission) BROWN (viper) wire to the brake wire behind the brake pedal switch
Brake (Manual Transmission) BROWN (viper) wire to BLUE/BLACK wire on drivers side kick panel (15 PIN CONNECTOR)
Neutral Safety Switch BLACK/WHITE to ground. You don’t need the switch. If you want to install it go ahead, but it is only used to disable the Remote Start.
Ribbon Wire to the Main Module
Viper 791 XV Installation Guide for Tiburon
Alarm, Door Lock, Trunk Release
Primary Module
(H1, H2, H3, Ribbon for Relay Satellite (only for remote start))
Viper ModuleCar
H1RED/WHITERELAY #85
RED12 VOLT SOURCE
BROWN+ SIREN
BLACKGROUND
VIOLETN/C
BLUERELAY #86 (1ST RELAY)
GREENRELAY #86 (2ND RELAY)
BLACK/WHITEN/C
WHITE/BLUEN/C
WHITEWHITE/BLACK (BCM 22 PIN CONNECTOR)
ORANGEN/C
H2LIGHT GREEN/BLACKN/C
GREY/BLACKN/C
GREEN/WHTIEN/C
VIOLET/BLACKN/C
WHITE/BLACKN/C
BLUEN/C
H3BLACK/WHTIEGROUND (OR SWITCH TO BYPASS RMT STRT)
VIOLET/WHITEWHITE (23 PIN CONNECTOR PASS SIDE KICK PANEL)
BROWNWHITE ((AUTO)BRAKE SWITCH)
BLUE/BLACK ((MANUAL) 15 PIN CONNECTOR DRV KCK PANEL)
GREYHOOD PIN (INCLUDED IN PACKAGE)(OR STOCK PIN, GREEN/ORAGNE WIRE CLOSEST TO FIREWALL ON PASSENGER SIDE KICK PANEL 23 PIN CONNECTOR)
BLUE/WHITEN/C
DOOR LOCKS
GREEN AND BLUE EACH GO TO THEIR OWN RELAY (DOOR LOCKS)
RELAY: SINGLE THROW, DOUBLE PULL (STDP)
85 – GROUND (-)
86 – GREEN FROM VIPER (2 PIN CONNECTOR)
87 – LIGHT BLUE ON BCM (12 PIN CONNECTOR) (BOTH RELAYS ARE TIED TOGETHER)
87A – N/C
30 – 12V
TRUNK RELEASE
H1 (VIPER) GOES TO GREEN/BLACK ON BCM (12 PIN CONNECTOR)
85 – RED/WHITE WIRE ON H1 ON VIPER
86 – 12V
87 – BLUE WIRE ON DRIVERS SIDE KICK PANEL
87A – N/C
30 – 12V