SPECIFICATIONS FOR a 10.5 Mixer Truck VEHICLE
It is the intent of these specifications to describe a conventional cab tandem dump vehicle with a set-back front axle to be used in construction service. The cab & chassis shall be equipped with all standard equipment as specified by the manufacturer for this model, and shall comply with all EPA Emission Standards and all Motor Vehicle Safety Standards as established by the U.S. Department of Transportation regarding the manufacture of motor vehicles.
THESE SPECIFICATIONS ARE TO BE CONSIDERED MINIMUM
MODEL
CONVENTIONAL CAB
Set-Back Front Axle Truck
ENGINE
Must be a minimumof a 13 liter at 375hp@1450 at 1100rpm
ENGINE EQUIPMENT
Oil Check & Fill: Engine Mounted
Valve Cover:
Air Intake: Center Top Cowl Air Intake W/Donaldson Air Cleaner Firewall Mtd
Alternator: Delco-Remy 145Amp SI 12v
Batteries: (3) Alliance 1031 Grp 31 12V Maint Free 2280 CCA w/threaded studs
Battery Box: Batteries Long Side to Rail: Heavy Duty
Battery Box Cover:
Positive Post for Jump Start: with Dust Cap
Battery cut off switch
Max speed 68 miles per hour
SPECIFICATIONS
Clutch None
Compressor: Bendix 13.2 CFM Series 550
Teflon Discharge Line
Engine Protection: Electronic Engine-Integral Shutdown Protection System
Exhaust Single Stat Cab Mounted
Exhaust Height: 11 6" (+0/-2")
Exhaust Piping: Curved Top Stack(s)
Exhaust Shield: Stainless Steel
Fan Drive: Horton HT/S Advantage On/Off Rear Aired, Air-On; Spring-Off
Fan Control: Automatic w/Dash Switch & Indicator Light
Fuel Filter: Remote MountPrimary
Full Flow Oil Filter:
Coolant Filter: Nalcool Need Release
Radiator: 1200 Sq In Brass/Copper
Heavy Duty Coolant: Ethylene Glycol w/Protection to - 30F Pre-Charged SCA
Coolant Hoses: Gates Blue Stripe EPDM
Coolant Hose Clamps: Constant Torque for Coolant Hose 1-3" Diameter
Radiator Draincock:
Engine Manufacturer’s own Full Engine Brake Retarder
Block Heater: Phillips 1500 Watt/110-120 Volt
Engine Heater Receptacle: Mtd Under LH Door
Flywheel Housing Aluminum
Starter: Delco Remy 12v 42MT OCP
Technical and Operator training to be provided.
Parts and Service manuals on CD’s
Software and adapters to hookup to a laptop for communicating with truck for codes and technical work (engine, transmission and brakes).
TRANSMISSION AND EQUIPMENT
Transmission: Allison 4500RDS 6spd
6-spd Gen 2/Utility/P&D/Truck, MD/HD Transmission Programming
Fill & Drain Plugs: Magnetic Engine Drain, Trans & R Axle File & Drain Plugs
Shift Lever: Dash Mounted Push Button
Transmission Oil Cooler: Water to Oil
Transmission must come with extended warranty (5year unlimited miles)
FRONT AXLE AND SUSPENSION
Front Axle:Minimum 20,000# Rating
Front Brakes: Meritor Cam 16.5X 7 Q+
Front Brake Linings: Non-Asbestos
Front Brake Drums: Gunite Outboard Mid Cast Iron
Front Brake Dust Shields
Front Oil Seals: Dana Spicer Outrunner
Spindle Nuts: Pro-Torque, Front Axle
Front Hub Caps: Vented-Oil
Front Auto Slack Adjusters: Meritor
Power Steering: TRW TAS-85
Power Steering Pump
Power Steering Reservoir: 2-Quart
Front Susp: Flat Leaf 20,000 #
Front Spring Pin Bushings: Graphite Impregnated
Front Shock Absorbers
REAR AXLE AND SUSPENSION
Rear Axle: Meritor RT-46-160P
5.38 Rear Axle Ratio
Rear Axle Carrier Housing: Iron
#2 Driveline: Meritor 176N Full Round Yoke w/Retained Needle (RN) Bearings
#3 Driveline: Meritor 17N
Driver Controlled Full Locking Differentials for Both Forward and Rear Axles as well as All Wheels
(2) Axle Valve & Light For Driver..... Controlled Traction Differential
Synthetic Lubrication: Mobil 75W-90 Rear Axle
Rear Brakes: Meritor Cam 16.5X7 Q+ Cast Spider, Dbl Anchor, Fabricated Shoes
Rear Brake Linings: Non-Asbestos
Brake Camshaft Support Brackets
Rear Brake Drums: Outboard Mounted Cast Iron
Rear Brake Dust Shields
Rear Axle Oil Seals: Chicago Rawhide
Parking Brake Chambers: MGM TR (2) Axles
Rear Auto Slack Adjusters: Meritor
Rear Susp: 46,000 Fully Independent Articulating Suspension
Rear Susp Ride Height: High
Rear Susp Control Rods: Fore/Aft and Transverse
BRAKE SYSTEM EQUIPMENT
Anti-Lock Braking System: WABCO Four Channel with (4 Sensor/4 Modulator)
Chassis Air Lines: Reinforced Nylon....Fabric Braid and Wire Braid
Brake Valves: Standard
Relay Valve: w/5-8 PSI Crack Pressure No Rear Proportioning Valve
Air Dryer: Bendix AD-9 with Heater
Air Reservoirs: Steel
Air Tank Drain Valve: Brake Bendix DV2 Drain Valve Wet Tank
WHEELBASE
Wheel base will be based on Mixer body specs.
FRAME
Frame: 1 1.81" X 4.14" X 7/16".....(8.73mm X 87mm X 258.8mm) Steel
C-Channel Insert: 1/4"(6.35mm) Full Length
Rearmost Cross member
End Frame: Square
CHASSIS EQUIPMENT
Bumper: 12"X1/4" Heavy Duty
Front Tow Eyes: (2) Retractable Frame Mounted
License Plate Mounting: Bumper Mounting Bracket (1) License Plate
Front Mud Flaps: Chassis Mounted Flaps And Hood Mounted Front Splash Shields
FUEL TANKS AND EQUIPMENT
LH Fuel Tank: 100 Gallon Aluminum
Fuel Tank Diameter: 26"
Fuel Tank & Band Finish: Painted Bands for Plain Alum or Painted STL Fuel Tank
Fuel Tank Locations: Forward
Step Finish: Plain Fuel Tank Steps
F/W Separator: Con-Met w/Sight Bowl....CMI-650
Fuel System: F/L Equiflo Inboard
Fuel Hose: Braided Wire Reinforced
Fuel Draw: Inboard
FRONT TIRES, HUBS, WHEELS
MICHELIN XZA1.....425/80R22.5 20 PLY
Front Hubs: ConMet Aluminum, High Capac
22.5 X 9.00 Frt Stl Accu HP10 Disc Whls Part Number 29300
Front Wheel Nuts: Mounting
REAR DRIVE TIRES, HUBS, WHEELS
MICHELIN XDN...... 11R 22.5 14PLY
Rear Hubs: ConMet Aluminum
22.5 X 8.25 RR Stl Accu HP10 Disc Whls Part Number 28408
Rear Wheel Nuts: Mounting
CAB EXTERIOR
Cab: CONVENTIONAL All Steel Cab ( No Aluminum Cabs )
Cab Mounts Airride
Fender Extensions Rubber
Extended Grab Handles: LH/RH
Grille: Bright Finish Surround
Bright Finish Aluminum Grille
Cab Kit: Heavy-Duty Cab w/Tunnel, Firewall & Dash Reinforcement
Hood: Fiberglass
Hood & Firewall Insulation: Hoodliner w/Double Firewall Insulation
Air Horn: Dual
Electric Horn: Single
Horn Shield: Dual
Key & Lockset: All Locks Keyed the Same (4 sets)
Headlights: Dual Halogen
Marker Lights: Aerodynamic Large
Stop/Tail/Turn lights: Integral Stop/Tail/Backup
Turn Signal: Standard Front Turn Signal Lights
Utility Light: LH Flush BOX
Primary Mirrors: Stainless Steel Powered andHeated West Coast Mirror Mounting: Door
Mirror Width: 102" Equipment Width
Auxiliary Mirrors: LH/RH 8" Convex Bright Finish Mounted Under Primary Mirrors
Down View Mirror: RH
Cab/Fender Mirrors: LH and RH
Reflectors: Standard Side/Rear
Exterior Visor: Fiberglass
Rear Window: 20' X 36"
Door Windows: Dual Power
Windshield: Tinted
Windshield Washer Reservoir: 1-Gallon
CAB INTERIOR
Interior: Custom,Grey
Floor Mats: Black w/Double Insulation
Dash Mounted Ash Trays & Lighter
Overhead Console:
Storage Pockets: 8" X 12" Manifest Box on LH Door
Cup Holder: (1) LH Dash
Heater & Air Conditioner: w/Defroster
Air Conditioner Control: w/ Recir Switch
Heater Plumbing: w/Shut-Off Valves
A/C Compressor: Climate Control 210
A/C Condenser Mounting Radiator
A/C Refrigerant: R134A
Silencer Package: For Cab
Circuit Protection: Auto Self-Reset Circuit Breakers
Wiring Schematic Card: Cab Mounted Wiring Diagram
Interior Lights: Door Activated Dome Lights w/Int Reading Light Over Doors
Door Locks: Dual Powered
Driver Seat: Bostrom Talladega 915 High Back
Pass Seat: Bostrom High Back Static
Door Mtd Arm Rests: LH/RH
Driver Seat Cover: Cloth Insert
Pass Seat Cover: Cloth Insert
Seat Belts: 3-point Driver & Passenger w/Retractors
Steering Column: Adj Telescoping Tilt with Driver’s Side Airbag
Steering Wheel: 20" 2-Spoke Black Cushioned
Interior Sun Visors: LH/RH
INSTRUMENT PANEL AND CONTROLS
Gauge Package Base Model Standard
Gauge Bezel Finish Matte Black
Driver Instrument Panel: Woodgrain
Low Air Pressure Warning Light & Buzzer
Air System Pressure Gauge Primary & Secondary Air Pressure Gauge
Air Restriction Gauge Dash Mounted
Back-up Aler: Preco 1040 Automatic Self-Adjusting
Cruise Control: Switch in Aux Control Panel
Starter Control: Dash Mounted
Diagnostic Connector: SAE 1587/1708 6- Pin Interface Connector Mtd under Dash
Fuel Gauge Electric
Coolant Temperature Gauge: Electric
Transmission Heat Gauge:
Engine Hour Meter: Hobbs
Engine Oil Pressure Gauge: Mechanical
Radio: F/L XTA-2100 AM/FM/
Radio: Speakers: (2) Speakers Mtd IN Cab
Radio Antenna: Center Forward Roof Mtd
CB Radio Provision: Power and Ground Studs in Dash
Speedometer: Ametek Electronic w/Trip Odometer
Tachometer: Electric
Additional Switches: (1) Dash Mounted Toggle Switch
Tractor Protection Valve:
Electric and Air Trailer Hookups at End of Frame for Towing
Voltmeter
Windshield Wiper Control: Electric with Intermittent Wipers Wired Thru the IGN
Marker Light Switch: Mkr LT/Headlt Swt W/Sep Interrupter for Clearance Lights
Parking Brake System: 1-Valve System w/Warning Indicator
Turn Signal Switch: Grote w/Dimmer
Turn Signal Flasher: HD Transistorized
PAINT DESIGNS
ONE COLOR DESIGN
Cab Color A: IMRON N0303 White
Chassis: Black High Solids Polyurethane
Bumper: BUMPER PAINTED SAME AS CHASSIS
Front Wheels: PRIMER WHITE FRONT WHEEL PAINT
Rear Wheels PRIMER WHITE REAR WHEEL PAINT
TRUCK BODY
10.5 Mixer specification
Body
Drum Capacity 10.5 cu yd
Discharge opening 42”
Drum Transmission ZF P7300
Head Thickness ¼”
Skin Thickness ¼”
Fin Thickness ¼”
Surge Fins Bolted
Hatch One,Bolted
Main Chute
Length 5’
Fold-over chute and Extensions
Lift- Engine driven
Lock- Air Chute
Length- Transitional 30”
Four Extensions – 4’
Three Chute holders mounted on passenger side of truck. Must have chute hold down straps
Water System
Tank- 125gallon steel tank
Location- side mount drivers side
All standard water system piped for injection line for drum, 25 ft hose at bottom for washing chutes and 25ft hose at top of platform for washing out. System must come with drain valves for draining.
Wash out for washing out chutes, system must have basket to separate water from material then pump water back into drum
Hydraulic
Pump – Eaton 54 Series
Motor – Eaton 46 Series
Reservoir – steel round
Reservoir Mounting – Front side of pedestal
Controls
Drum Revolution Counter mounted in cab
Drum controls and throttle control – Mounted inside cab and outside on drivers side ladder platform
Pedestal
Front – 3/16” Thickness
Rear – 3/16” Thickness
Ladder platform – Wide
Platform Gate – Upper Ladder Platform Gate
Fenders
Heavy Duty steel fenders with mud flaps on rear of truck and front of the fenders