Purchase Specificationfor a
Wireless Handheld Controller
for Airfield Lights
Overview
This specification is for a wireless handheld controller for airfield lighting and is herein referred to as the “HHC”. The HHC shall be of rugged, weatherproof military-grade construction and provide on-command control of the airfield via encrypted signals.
1.0 Mechanical
The HHC shall comply with the following specifications:
- Housing Die-cast aluminum
 - Military green
 - Weight: 1.36 kg (3 lb.)
 - Dimensions: 4 X 8 X 2.5inches (10.16 x 20.32 x 6.35 cm) (excluding antenna)
 - Waterproof Tested to Condition B, Method 104A of MIL-STD-202 (IP67 Equivalence)
 - Military Grade construction
 - Gore™ venting
 - Shock and vibration
 - The operating temperature range shall be -40 to 140 ˚F (-40 to 60 ˚C)
 
2.0 Antenna
The HHC antenna shall comply with the following specifications:
- Omni-directional, 1/2 wave dipole, 50-ohm
 - Removable
 - HHC range can be increased through the use of optional extension coaxial cable
 
3.0Controller Interface
The HHC controller interface shall provide the user the following:
- Variable intensity LED backlit silicone keypad
 - On power up, all buttons illuminate to confirm all backlighting is operating correctly
 - LEDs to indicate active control groups
 
4.0 Radio
The HHC radio module shall comply with the following requirements:
- FCC certified
 - Transmission Range of up to 4 km (2.5 miles)
 - 902-928MHz ISM band
 - FHSS (Frequency Hopping Spread Spectrum) using 50 channels
 - Point to Multipoint
 - Transmit power of 1 W
 - Multiple retransmits to ensure signal receipt by airfield equipment
 - Shall not use mesh network because of the vulnerability to intermediary light failure
 
5.0 Batteries and Electrical
The HHC battery system shall comply with the following requirements:
- Type:lithium ion, long cycle life series
 - Voltage:3.75 V
 - Capacity:6800 mAh
 - Battery Life:
 - 12 Hours (1 operation per minute)
 - 1250 Hours (storage)
 - Recharge time: 5 hours
 - External charger included with HHC(12Volt DC output / 100-240VAC50/60Hz input, international tips)
 - The battery shall be rechargeable, replaceable, and recyclable
 - The manufacturer shall offer complete battery replacement kits
 - The HHC shall provide indicator LEDs for battery charging and charge status
 
6.0 Connectors
The HHC shall be equipped with the following three (3) military-grade electrical connectors:
- ARCAL Control Input
 - 12 Volt DC Power Supply input
 - RS-232 Bi-Directional Serial Data
 
7.0 Feature Control
The HHC shall offer the following feature set:
- 256-bit AES secure encryption
 - Emergency Flash (max brightness, flashing)
 - Instant Airfield Blackout or Infrared for immediate threat response
 - Define up to 8 separate groups for individualized control
 - Capable of Flashing individual airfield groups 0.25 sec ON 0.75 sec OFF)
 - Remote battery charge inquiry
 - Battery Status
 - ARCAL Pilot airfield control when HHC is connected to commercial ARCAL VHF equipment.
 - Autonomous and Temporary Mode
 - Six Intensities (Auto-Low, Auto-Medium, Auto-High, Temp-Low, Temp-Medium and Temp-High)
 - Visible/Infrared output toggle
 - User and Administrator Password Control
 - Unique pairing of an individual HHC to an individual airfield for secure, exclusive control
 - Diagnostics
 
8.0PC-Based Software
The HHC shall be capable of PC software control via the built-in RS-232 data connection.
9.0 Environmental Testing
- MIL-STD-202:Humidity, Immersion, Vibration, Shock
 - EN 60945: ESD, EMI, EMC
 
10.0 Approvals
The HHC shall be FCC and ANATEL certified.
11.0 Quality Assurance
The HHC, except for the battery pack, shall be guaranteed for a minimum of three (3) years. The battery pack shall be guaranteed for one (1) year.
The manufacturer shall be ISO 9001 certified.
1of 3
