INSTALLATION INSTRUCTIONS PART# TRS450KPX

KEYPAD OPERATION INSTRUCTIONS

NOTE: THE FACTORY DEFAULT USER CODE FOR THE KEYPAD IS “1 2 3 4”.

PLEASE FOLLOW THE INSTRUCTIONS BELOW TO CHANGE THE

USER CODE IF YOU DESIRE TO.

CODE LEARING:

  1. Make sure the system is in Disarm mode.
  2. Turn the ignition key ON, OFF, ON, OFF, and back ON.

*Within 3 seconds the siren/horn will chirp/honk 3 times.

3. Within 15 seconds press and hold the valet switch for 5 seconds. The siren/horn will

Chirp/honk 5 times, LED will illuminateto indicate the system is in code learning mode.

  1. Enter the default user code (1 2 3 4) from the keypad, then press the 9/0 button to send the keypad code to the system. The siren/horn will chirp/honk once to indicate it has learned the code.
  2. You MUST learn all the transmitters at the same time. Please refer to the installation instructions how to program the rest of the transmitters.

(MAXIMUM OF 4 OF ANY COMBINATION OF TRANSMITTER CAN LEARN INTO THE SYSTEM)

.

KEYPAD OPERATION:

  1. Enter the 4 digit user code then press button 1/2 on the keypad momentarily. The module will send a signal to DISARM the system and UNLOCK the doors. The parking will flash twice and the LED will turn off to confirm the operation.
  2. Enter the 4 digit user code then press button 3/4 on the keypad momentarily. The module will send a signal to ARM the system and LOCK the doors. The parking will flash once and the LED will flash slowly to confirm the operation.
  3. Enter the 4 digit user code then press and hold the 5/6 on the keypad. The module will send a signal to open the trunk or any accessory is connected to the WHITE/BLUE wire.

CHANGE USER CODE: (3 ~ 7 DIGITS)

  1. Press and hold button 9/0 for 3 seconds. The LED of 9/0 button will flash 3 times and back lights flash twice.
  2. Enter the current user code and hold the last digit for 2 seconds. If the current user code is correct the LED of 9/0 button and back lights will flash once. If the current user code is incorrect the LED will flash twice to exit the code change mode. Please repeat the step 1 & 2 again.
  3. Enter the NEW user code that you want to change (3~7 digits), hold down the last digit for 2 seconds. If the NEW user code is accepted, the LED and back lights will flash once. If the NEW user code is NOT accepted, the LED and back lights will flash twice to exit the code change mode. Please repeat the steps again.
  4. Repeat the NEW user code again (MUST BE THE SAME CODE AS STEP 3); hold down the last digit for 2 seconds to confirm the code. If the NEW code is accepted the LED and back lights will turn OFF to confirm the NEW code has been changed successfully. If not, LED will flash twice to exit the code change mode. Please repeat the steps above again to change the NEW user code.
  5. If the NEW user code has been changed. PLEASE write it down and keep at save place. If you lose the NEW code and there is NO way that we can retreat your NEW code.