G120934 GUTTER LIGHT SET OF 2 INSTRUCTION SHEET

IMPORTANT:

  • Remove the clear protective film from the solar panel before installing.
  • Turn the switch to the ON position. The item will work automatically, charging by day and lighting by night. (In order to verify that the switch is correctly switched ON cover the solar panel with your hand and the light will turn ON automatically.)
  • Select an outdoor location away from night light sources, such as street lights, which may cause the light to turn OFF automatically. Duration of light depends on the level of sunshine exposure, geographical locations, weather conditions and the hours of daylight.
  • Keep the solar panel clean. Wipe with a dry cloth.
  • Leave the switch in the ON position.

INSTALLING INSTRUCTIONS:

  • Insert the bracket into the slotted section of the light fixture as indicated on the illustration below (left). Install the bracket so the clip is facing downward in the same direction as the LED lights as referenced in the example below (right).


  • Secure the bracket to the light fixture using the provided 0.50” length screw. Note that the light fixture has two holes to secure the bracket they are to provide an adjustable distance from the light fixture and the gutter when installed.
  • To install the item on a flat surface simply place the bracket against the surface and mark the two holes.
  • Drill through the center of both holes using a 1/8” drill bit
  • If the wall is hollow drill through the same holeswith a ¼” drill bit and insert the wall anchors into the hole. Tap in the wall anchors lightly with a hammer until the anchorsare flush with the wall surface. If you hit a wall stud use only the enclosed screws.
  • Secure the bracket to the flat surface with both 1.25” length screws (included).
  • To install the item on to a gutter simply open the clip and place the outer wall of the gutter in-between.
  • You may need to adjust the item to direct light downward, to do so simply bend the metal bracket that connects the light fixture to the clamp. Make sure to hold the metal bracket and not the light fixture when adjusting to avoid damaging the item.

CAUTION:

  • IF BATTERY CONTENTS ARE LEAKING, DISCONTINUE USE AND RECYCLE.
  • IF YOU HAVE ANY DOUBTS ABOUT THE INSTALLATION SEEK THE SERVICES OF A QUALIFIED INSTALLER.

THE PRODUCT OPERATES USING 1 X AA NI-MH 1.2V RECHARGEABLE BATTERY (INCLUDED)

Imported By: S&S ENTERPRISES LTD, 26 PERIVALE PARK, Perivale, UB6 7RLMade in China