Section 1 - Product Identification and Use

M A T E R I A L S A F E T Y D A T A S H E E T

======

SECTION 1 - PRODUCT IDENTIFICATION AND USE

Product identifier:ASTRO DEGLAZER

Product use:Deglazer for ink rollers and blanket.

Manufacturer’s name:Nikken Chemical Laboratory Co., Ltd.

Address:16-1, Sakae 2-Chome, Naka-Ku, Nagoya 460, Japan

Emergency Tel/Fax no.:Tel: +81-52-204-0558 / Fax: +81 52 219 2495

======

SECTION 2 - COMPONENT HAZARD DATA

Component(s) CAS Number Percentage ranges

(%)

Mineral spirit8052-41-310.0 - 30.0

Ethylene glycol alkylether110-76-210.0 - 30.0

Malonic acid141-82-25.0 - 10.0

Phytic acid83-86-31.0 - 5.0

Water7732-18-510.0 - 30.0

======

SECTION 3 - PHYSICAL DATA

Appearance and odor:Colorless liquid; Petroleum odor

Boiling point:N/D

Specific gravity(H2O=1):< 1

Vapor density(air=1):> 1.0

Vapor pressure:N/D

Solubility in water:Partly soluble.

Percent volatile by volume(%):N/D

Evaporation rate:N/D

(n-butyl acetate=1):< 1

======

SECTION 4 - FIRE AND EXPLOSION DATA

Flash point and method:43℃(TCC)

Auto-ignition temperature:N/D

Extinguishing media:Dry chemical; carbon dioxide; CO2 halogen agent.

Special fire fighting procedures:Use self-contained air supply for respiratoryassistanceand

wear protective clothing toprevent contact with skin and eyes.

Unusual fire/explosion hazards:None.

======

SECTION 5 - REACTIVITY DATA

Chemical stability:Stable.

Conditions to avoid:Avoid exposure to high heat sources, open flame, and

strong oxidizing agents.

Incompatibility:Avoid strong oxidizing agents.

Hazardous decomposition product:None.

Hazardous polymerization:Will not occur.

======

SECTION 6 - TOXICOLOGICAL PROPERTIES

Route(s) of entry:Inhalation; ingestion; skin contact; eye contact.

Effects of acute exposure:May be mild irritation to skin, eyes, nose, and throat.

Effects of chronic exposure:Prolonged and repeated overexposure may causedermatitis.

Carcinogenicity:The components of this product haven’t shown anyevidence

of carcinogenicity.

Page 2

ASTRO DEGLAZER

======

SECTION 7 - PREVENTIVE MEASURES

A) Special Protection Information

Respiratory protection:Not normally required.

Ventilation:Local exhaust: Recommended.

Mechanical(General): Should be sufficient in work area.

Skin protection:Latex; dry rubber; Neoprene water-proof gloves.

Eye protection:Safety glasses to avoid chemical splash.

Other protective equipment:Rubber or plastic apron.

B) Spill, Leak, and Disposal Procedures

Spill or leak:Minor spills may be absorbed with ground clay,vermiculite,

or similar absorbent material. Use chemical vacuum or

other safe and approved method to removemajor spills.

Then place into proper containers for legaldisposal.

Disposal:Consult with Federal, State, and/or local regulatoryagencies

for appropriate disposal methods.

C) Special Precautions and Comments

Special handling & work practice:Do not take internally. Ventilation in work area should

be sufficient. Remove and wash contaminated clothing

immediately. Keep containers tightly closed and wash

hands thoroughly after use.

Storage requirements:Store this product in a cool, dark, and well-ventilated

place, away from open flame, extreme heat and fire

hazards.

======

SECTION 8 - FIRST AID MEASURES

Eye contact:Immediately flush eyes with water for 15 minutes. Call

a physician.

Skin contact:Wash thoroughly with soap and water. Remove

contaminatedclothing.

Inhalation:Remove victim to fresh air.

Ingestion:Drink one or two glasses of salty water and induce

vomiting by sticking finger. Seek medical attention.

======

SECTION 9 - PREPARATION DATE OF MSDS

Date of preparation:May 21, 2001

Prepared by:Nikken Chemical Laboratory Co., Ltd.

Telephone:Japan +81-52-204-0558

Facsimile:Japan +81-52-219-2495

======