C.V
Ayman Ibrahim Mohamed Ashour
Phone: 002-0122/3667538-01018007330 E-MAIL:
002-040 (3598177- 3416129)
El read towers, tower”9B” Level 6 from El fateh Street -Tanta-Egypt
Attention:
The Human Resources Manager:
I have the pleasure to introduce myself to you, hoping that my qualifications meet your requirements.
Personal Information Date Of Birth :March7, 1973.
Marital Status :Married.
Military Status :Done.
Nationality :Egyptian.
Passport No. :A15955209
Length :186 cm.
Weight :98 Kg.
Computer Skills: Ability to use: (Windows-WinWord-Exile - out cad- Internet applications).
EducationUniversity :AlmnofiaUniversity
Degree :BS.C
Department :Electrical of Engineering
LanguagesArabic :Mother Tongue.
English :Good
Position : Chief Electrician
Previous Experience
1- Work in Global Santafe Transocean (Shelf Drilling).
Corp. on Offshore Rigs in the Maintenance Department as Electrician from: 2002 -June.2005.
2- Work in Global Santafe Transocean (Shelf Drilling)105&141Key Singapore Juke UP Rigs off shore
Corp. on Offshore Rigs in the Maintenance Department as a Chief Electrician from: June 2005 -31, July, 2014
3- Work in Pyramid Company.
Corp. on Offshore Rigs in the Maintenance Department as a Chief Electrician from: -1, August, 2014 at now.
My duties are looking after the daily electrical maintenance as per the computerized, (RMS) JD edwar, Protective Maintenance Programs (PM), of (Global Santafe Transocean) Shelf Drilling 105&141Key Singapore andPyramid Company on Pennevis Rig Jake UP Rigs off shoreCorp.
We also adhere to a strict Permit to work and isolation, system in safety a conscious environment.
Type of work:
I have over the past 15 years gained experience of repair and maintenance of the following equipment.
-I have good background about line diagram [control circuit]
-Repair and proper maintenance of electrical equipment in hazardous areas, maintaining flame paths, Proper cable gland selection etc.
- Repair and Troubleshooting of A/C motors and associated control gear.
- Repair and Troubleshootingof DC motors 752 GE and controller for Mud pump, Draw works, Rotary table and Top Drive including stripping and overhauling.
- Repair and Troubleshootingof LE-Torneau (Marathon Crane) A/C motors ,MG set and control gear, including LE Torneau Cranes.
- Repair ACTroubleshootingand recovery procedures of Carrier air conditioning and refrigeration equipment
- MSA gas alarms and associated sensors, and some experience of calibrating same.
- Repair and Troubleshootingof GAI-Tronics communication, PA system, plus TV sat systems and adjust internet connection.
-Troubleshooting power and control for air compressor units.
-
Troubleshooting PLC for Top Drive & DAQ for Rig Sense system.
_ Install and repair the CCTV system.
-Troubleshooting KEMS.
-Troubleshooting Elmagco Electrical brake, Elmagco Battery Back up and repair for coils.
-Install and Repair service loop for top drive.
-Repair and Troubleshooting Main generators Katoand main power supply (switch board).
- Repair and Troubleshooting SCR units Controllers (Rose hall, GEI & GE III)
- I have also been involve in rig upgrade shipyard work which involved stripping out and re-wiring on a larger Scale than the usual day to day duties on the rig.
-I have also a good working relationship with senior personnel and general workforce on the rig.
Training
1- Electrical Courses:
Theoretical and Practical Training Courses in the entire above mentioned subjects.
- Electrical Fundamentals course
-Maintenance system Course for Crafts
-Safety Leadership Training- Supervisor Level.
-DAQ 4/Rig sense 2.0 System
- Rig system Gould bass - motor generators course.
- Complete ability to use RMS (JD edwar) Program (Rig Management System) (a computer program designed for calculating the time of both PM's(Predictive Maintenance Preventive Maintenance).
- Refrigerant Recovery.
- Explosion Proof electrical equipments,(Singapore)
- High Voltage & low Voltage switches. (Aberdeen)
2- Safety Courses:
- Safety Management Leadership(SML)
- Advanced Safety Audit (ASA)
- Life Boat Course at the ArabAcademy for Technology & Maritime Transportation.
- FOCUS (Field of observation continuously updating safety).
- STOP (Safety Training Observation Program).
- Confined space.
- Permit to work.
- Chemical Hazards.
- Rig Induction.
- Helicopter training.
- H2S.Training.
- Asbestos Containing Material Awareness.
- RMS (Rig Management System) Program I& II.
- Manual Handling.
- JRA (Job Risk Assessment).
- Lock out and Tag out.
- Face To Face.
Thank you, for giving me a chance to introduce myself,
Best Regards,
AYMAN IBRAHOM MOHAMED ASHOUR
1 of 4