IllustratedWord 2016| Module1: SAM Project 1a

IllustratedWord 2016| Module1: SAM Project 1a

Film Buff Blog

COMPLETING A BLOG POST

GETTING STARTED

  • Open a NEW Word Document
  • Save the file as Chapter1_FilmBuffBlog.docx
  • If you do not see the .docx file extension in the Save As dialog box, do not type it. The program will add the file extension for you automatically.
  • With the file IL_WD16_1a_FirstLastName_2.docx still open, ensure that your first and last name is displayed in the footer.

PROJECT STEPS

  1. Type the document then apply the following formatting.
  2. You contribute to a blog for film enthusiasts, which is ranking the 100 greatest films of all time. You are writing a blog post about the filmCasablanca. Begin by formatting the blog title “Film Buff Blog” in bold.
  3. In the first line, increase the font size of the text“Film Buff Blog” three times. (Hint: The size of the text should be 16pt. when you are finished.)
  4. In the fourth line, decrease the font size of the text “Rank: #10” three times. (Hint: The size of the text should be 11pt. when you are finished.)
  5. Center the first four Lines beginning “Film Buff Blog” and ending “Rank: #10” so that the Linesstand out from the body of the blog post.
  6. In the first body paragraph, bold the text “Plot summary” to call attention to the text. (Hint: Select only the words “Plot summary” and not the colon following the words.)
  7. Add a Bottom Border to the fourth body paragraph (“Without telling Ilsa,…in the movie.”) to separate the plot summary from the rest of the blog post.
  8. Add anOutside Border to the first body paragraph beginning with Plot Summary and ending with nobody.”
  9. Add a 1 ½ pt. Text Border to the Title Film Buff Blog at the beginning of the entire document. (try to match the one shown in the example).
  10. Add the following font changes as indicated.
  11. World Word II – Italics (paragraph 1)
  12. Round up the usual suspects – Underline (paragraph 4)
  13. Trivia and Bloopers - Shadow Outer Offset Left (bottom of the document)

Your document should look like the Final Figure on the following page. Save your changes, close the document, then exit Word.