April 2012
FLYING SCOT 5861 FOR SALE
$16,500
Purchased new from Flying Scot Inc. in October 2008. Radical Racing Package installed at the factory when the boat was built. White hull and deck, with dark blue stripe at water line. Snug rig. Three complete sets of sails. Includes galvanized steel trailer and multiple covers. Prepared and ready to compete with the leaders at any regatta. Successful racing record –results attached. Located in Richmond, Virginia. Contact Mike Miller at 804-230-4985, or .
LONG TRAILER – Galvanized steel.
-2” diameter ball hitch.
-Spare Tire mounted on front of trailer.
-Tongue Jack with exceptionally wide nose wheel.
-Bearing Buddies installed.
-Mud Flaps installed.
-LED Lights installed on wooden light bar with pintel that fits in the top gudgeon on the transom of the boat.
-Padded hull tie down strap.
-Center board stabilizer.
PROTECTIVE COVERS –
-North Bottom Cover- used when trailering the boat. This cover was installed on the bottom of the boat every time the boat was trailered.
-North Top Cover- used when trailering the boat, or when the boat is sitting on the trailer fully rigged. This cover covers the entire top and sides and transom of the boat down to the water line. It wasusedevery time the boat was trailered, and at away regattas.
-North Full-Length Mast Cover. This cover was installed on the mast every time the boat was trailered.
-Sailors Tailor Top Cover. Full top cover, with skirt that covers the sides, bow and transom of the boat to below the waterline. This cover was used when the boat was dry sailed out of our home sailing club.
-North Rudder Bag. When off the boat the rudder was immediately placed in the rudder bag. The rudder was always transported and stored in the rudder bag.
-SAILS – Three complete sets. All sets are snug rig with standard cut.
-MADDMain and Jib delivered July 2010. Sails used only three times - at 2010 Nationals, at 2010 Capital Districts, and at 2011 Nationals. Main has large window. Jib has small Harken blocks attached for 2:1 sheeting.
-MADD Main, Jib and Spinnaker delivered spring 2009. Sails used for 2009 Mid-Winters, 2009 Nationals, 2009 Capital District Championship, 2009 Atlantic Coast Championships, and later regattas. Main has large window. Spinnaker is AirX white material. Jib has small Harken blocks attached for 2:1 sheeting.
-North Spinnaker delivered summer 2008. Used at Nationals, Mid-Winters, Atlantic Coast Championship and Capital District Championship regattas. BR-1 Radial cut of AirX white material.
-North Main and Jib. Oldest sails of the three sets. Used for practice days and club racing. Jib has small Harken blocks attached for 2:1 sheeting.
-Shore Spinnaker. Oldest spinnaker that is used for practice days and club racing.
Additional items included with the boat–
-Mast Head Fly.
-Boom and Mainsheet are rigged for main sheet mechanical purchase of either 1:1, 2:1 or 3:1.
-Light Weight, Soft, Floating Mainsheet.
-Boom has Internal Outhaul, and Cascading Vang.
-Spinnaker Pole is tapered aluminum.
-Two Spinnaker Shelf / Bags. Forward ends of both port and starboard seats have a shelf / bag installed. Starboard shelf / bag has an attached pocket with Velcro closure for storage of miscellaneous items.
-One set ofLight Air and one set of Heavy AirSpinnaker Sheets. Both sets of sheets are soft, lightweight, floating.
-Low Friction – Easy Running Jib Sheets. Easily changed from 2:1 to 1:1 purchase.
-All Cam Cleats for control lines or sheets have Aluminum Cams. The plastic cams were removed.
-Platismo Contest Compass with cover is installed on aft side of mast tabernacle.
-Bow Bag with protective cover.
-Minimum Weight Anchor and Line, securely stowedon floor on centerline of boat forward in front of mast tabernacle or aft near transom.
-Light Weight Plastic Paddle securely stowed in clips on underside of port deck, forward of mast.
-Bucket, Bow Line, and Sail Ties. Securely stowed beneath starboard seat.
-One Stainless Steel Halyard Cranksecurely stowed on port side of mast tabernacle.
-One spareCast Aluminum Halyard Crank.
-Two Hiking Linesare removable. For use when sailing with total of three crew on windy days.
-Lifting Bridle.
-Plastic bin securely stowed on floor beneath port seat for miscellaneous tools, parts, …
-Retainer clip for boom crotch on floor beneath starboard aft deck.
-Secure holders for two water bottles, one each on floor beneath port and starboard seat.
-Shock cord installed on underside of port seat to securely stow soft items.
-Two zippered storage pockets -one on starboard side of mast tabernacle, and one at aft end of starboard seat.
-Pencil holder on starboard side of mast tabernacle.
-The boat has successfully measured and weighed in several times at Nationals and Mid-Winters.
REGATTA RESULTS FOR # 5861 -
-2009 Regatta Results –
-AtlanticCoast Championship Regatta – Tied for1st place overall.
-Capital District Championship Regatta – 1st place overall.
-Blackbeard Sailing Club Regatta, New Bern, NC – 1st place overall.
-Greater Richmond Sailing Association Fall Regatta – 1st place overall.
-Sarasota Mid-Winters Warm Up Regatta – 2nd place overall.
-Fishing Bay YC Annual Regatta, Deltaville, Va – 2nd place overall.
-West River Sailing Club Regatta, Galesville, Md – 2nd place overall.
-Greater Richmond Sailing Association Spring Regatta – 2nd place overall.
-Great 48 Regatta at Lake Norman YC – 3rd place overall.
-SelbyBay Summer Solstice Regatta – 3rd place overall.
-2010 Regatta Results -
-Capital District Championship Regatta – 3rd place overall.
-Doc Gilbert Regatta at LeesylvaniaState Park – 2nd place overall.
-In 2010 and 2011 the boat was not used much, and rarely sailed in a regatta.
ITEMS OFFERED FOR SALE SEPARATE OF THE ABOVE –
-One new Centerboard Gasket. Dacron material. Purchased from Flying Scot Inc,part # 450100.
-One new Mast Head Fly – Sparfly by Davis. In box. Davis part # 1310.
-One new Mast Head Fly – Windex by Davis. In box. Davis part # 3101 W10.
-Six new Cast Aluminum Handles for Halyard Box. Flying Scot Inc. part # 120038.
-One new Set of North Mainsail Battens – Tapered.
-One Spare boom. Fully rigged with internal outhaul, Harken blocks ready for mainsheet mechanical purchase of either 1:1. 2:1 or 3:1, and mainsheet whoopee.
-One Halyard box. Complete. Ready for re-installation on a mast.
-Two Forestay Extension Cables, Flying Scot Inc. part # 660038. One new. One used. Used one includes turnbuckle, toggle, and extension plate, and all wire strands are in good condition and show no wear.
-One Loos Standard Shroud Tension Gauge. Loos model A, part # 91. For wire diameters 3/32”, 1/8”, and 5/32”.
-One Loos Professional Shroud Tension Gauge. Loos model # PT-1. For wire diameters 3/32”, 1/8”, and 5/32”.
-Miscellaneous serviceable used parts – centerboard rollers; spinnaker pole end fittings; boom gooseneck slide fitting on mast; new and used Harken blocks and Harken cleats.
Page 1 of 4