TDSP “Cutover” Form for EPS Metering Points

Purpose: This form shall be submitted by the TDSP to facilitate the transfer of information required to add or remove an EPS meter point in Lodestar ERCOT settlement systems for:

  • Generation Facilities
  • NOIE Boundary Metering Points
  • Other Qualified Metering Points

Instructions:

  • Submit completed form to EPSepsmm and,1DataLoadingandAggregationERCOTEAADataAggregation@ercot.com., and TDSP ERCOT Client Services Representative.
  • This form should be submitted no later than 14 cCalendardDays before the requested “cCutover” date.
  • This form does not replace other documentation requirements from Market Participants.

  1. Meter Point Identification & Certification Information

TDSP Project # / Design Proposal Approval Date / Design Proposal Approval Date
Facility Name from the approved Design Proposal
Unit or Load Name (s) from the approved Design Proposal
Meter ID (s) from the approved Design Proposal
Device ID (s) from the MDAS Configuration Form
Date that the metering point (s) was/were/will be certified by a TDSP EPS Meter Inspector and found verified to be in compliance with ERCOT Protocols and SMOG
Date that the meter(s) established/will establishof successful meter communications with the ERCOT MDAS group
TDSP Proposed Start Date for cutover, adding a meter point (s)
(Date that ERCOT will provide data for Settlement) (N/A if only stopping meters) / (Date that ERCOT will provide data for Settlement)
TDSP Proposed Stop Date for cutover, removing a meter point (s)
(Date that ERCOT will stop providing data for Settlement) (N/A if only starting meters) / (Date that ERCOT will stop providing data for Settlement)
Comments
  1. TDSP Contact Information

TDSP nName / Form cCompletion Ddate
TDSP contact requesting cutover / Contact pPhone number#
TDSP contact e-mail address
Comments
3.ERCOT Confirmation of Proposed Cutover Date
Name of TDSP ERCOT Client Service Representative contacted.
Date their ERCOT Client Service Representative confirmed the proposed cutover date for this site.
  1. TDSP Verification of Resource Agreement with TDSP Proposed Cutover Date

Resource cCompany Nname
Resource contact name approving cutover / Contact pPhone number#
Resource contact e-mail address
Date the rResource contact agreed with the proposed TDSP cutover date.
Comments

Version 32.01Page 1 of 333/823/20176

TDSP “Cutover” Form for EPS Metering Points

  1. EERCOT Information

ERCOT verifies that the ERCOT systems are ready for the metering point to be established/removed as an EPS metering point. Cutover dDate for this metering point approved or changed by ERCOT as indicated below.
Date cutover form approved by ERCOTApproved Start Date / ERCOT Representative
Comments

Revisions to the TDSP Cutover Form shall be made according to the approval process as prescribed in the Settlement Metering Guide Section 3.4, EPS Metering Facility Processes and Forms.

Version 32.01Page 1 of 333/823/20176