SELF BALLASTED LED LAMP FOR GENERAL LIGHTING SERVICES AS PER IS 16102(PART-1):2012

FOR PARTICIPATION IN COMPULSORY REGISTRATION

(CRS)SCHEME NOTIFIED BY DEITY

Applicant’s name &Address
Manufacturer’s name & Address:
(In Registration scheme)
Test item description / Self Ballasted LED lamp for General Lighting
Services
Trade Mark
Model/Type reference
Rated current (A) / Rated voltage (V):
Overall size of the equipment : / W: / mm, H: / mm, D: mm
Mass of the equipment (kg): / Kg
Marked degree of protection to IEC / IPXX
60529
Series Formation Basis, if applicable / Models included in this series
Similarities
Differences
Worst Case
Max. Accessories used
Model / sample submitted for testing
Supporting documents for validation / Documents Required for each model in
of series formation and selection of
series
sample (Refer Guidelines for Series
Approval / of / Products / for / 1. / Mains board layout & circuit diagram
Implementation of / “Electronics / 2. / Enclosure drawing with material details
Information technology Goods” / 3. / Power & Hot Spots
Following conditions to be fulfilled for series
formation as per DeitY guidelines
1. / Same rated / Input Voltage
2. / Same cap design
3. / Same PCB Design and layout
4. / Same ratings of ballast ( LED Gear) /
Driver Circuit

LIST OF SAFETY CRITICAL COMPONENTS LIST( SELF BALLASTED LED LAMP FOR GENERAL LIGHTING SERVICES )

Object/part / Manufacturer/ / Type/model / Technical / Standard / Mark(s) of / Supporting
no. / trademark / data / conformity. / documents
Enclosure, if
non-metallic
Mains / SMPS
Transformer
X-Y
Capacitors
MOV/Surge
suppressor, if
used
PCB
Appliance
connectors/
inlet, if used
Opto-coupler
LED, if used,
laser class
Internal wire

Notes:

  1. A qualified Technical Person is required to give the demonstration of product and provide clarifications as requested.
  1. The sample submitted should be a complete unit, Additional Enclosure if feasible, Circuit Schematic Diagram, Block Diagram, PCB

Layouts,List of Safety Critical Components (Test Reports from

CBTL/BIS/IEC17025 approved Lab) and Instruction & Service Manual with technical specification.