Page 1 of 3

MATERIAL SAFETY DATA SHEET

Product Name: Blue Cling Film

SECTION I – IDENTIFICATION

Synonym: Polyvinyl Chloride Film; PVC film; Vinyl film

Manufacturer’s Name: Anchor Industries

Address: 13515 Barrett Parkway Drive

Ballwin, MO 63021

Formula: Trade Secret

Chemical Family: Organic Polymer with additives

Date of Preparation: August 22, 2005

SECTION II – HAZARDOUS INGREDIENTS

Polyvinyl chloride contains vinyl chloride monomer in the order of 1 to 10 ppm by weight. Vinyl Chloride monomer is a cancer-suspect agent. Manufacture, handling, and processing of polyvinyl Chloride are specifically regulated by US Department of Labor, Occupational Safety, and Health Administration. It is not known to be a requirement for special handling techniques of PVC when in meat film form. But, handlers and processors of Polyvinyl Chloride should be familiar with these regulations, 29 CFR 1910.1017. None of the information presented in the material safety data sheet should be construed to contradict or supersede these regulations.

Dioctyl Adipate (DOA) in its chemical form is defined as a toxic chemical under, and subject to the reporting requirements of Section 313 of Title III of the Superfund amendment and re-authorization Act of 1986 and 40 CFR Part 372. This product is not considered a hazardous chemical under the criteria of the OSHA Hazard Communication Standard (29 CFR 1910.1200). This is used as an additive in PVC films and in this solid form is not considered a hazardous material. It is biodegradable material.

All materials and additives are approved by the USDA and FDA for food use, when in film form.

SECTION III – PHYSICAL DATA

Boiling Point: Softens above 175 degrees

Solubility in Water: N/A

Page 2 of 3

Freezing Point: N/A

Melt Flow: N/A

Appearance & Odor: Clear colorless to slightly yellow in natural state.

Colorant may be added. Odorless.

Form: Solid

% Volatile by Volume: 0.5%

Specific Gravity: 1.3 – 1.4 @ 25C

SECTION IV – FIRE AND EXPLOSION HAZARD DATA

Flash Point: N/A

Flammable Limits in Air: N/A

Extinguishing Media: Dry powder or CO2. Decomposed polyvinyl chloride

Residue may float on water.

Special Fire Fighting

Procedures: Respiratory protection is necessary due to presence of hydrogen chloride.

Unusual Fire and

Explosive Hazards: Upon prolonged heating, polyvinyl chloride will decompose with emission of hydrogen chloride (HCL), and irritating toxic gas. The decomposed residue will burn in the fashion of hydrocarbon tar.

SECTION V – HEALTH HAZARD DATA

Threshold Limit Date: None known to Anchor Industries.

Effects of over exposure: None known to Anchor Industries – Mild allergic dermatitis may occur with handling of ground rolls without gloves.

Emergency and First

Aid Procedures: Skin contact of ground material may be treated by washing with soap and water. Ingestion and eye contact should be treated as with other inert solids.

SECTION VI – REACTIVITY DATA

Stability: Thermally Unstable

Hazardous

Polymerization: Will not occur

Conditions to Avoid: Avoid prolonged heating to cause instability and

Decomposition which produces hydrogen chloride (HCL).

Incompatibility: Polyvinyl chloride is known to dissolve in some aromatic and halogenated solvents.

SECTION VII – SPILL OR LEAK PROCEDURES

Spill Response: N/A

Page 3 of 3

Waste Disposal Method: Landfill as non-hazardous waste, plastic recycle, or incineration.

Reportable Quantities: N/A

SECTION VIII – SPECIAL PROTECTION INFORMATION

Ventilation: No special ventilation required.

Respiratory Protection: Detailed requirement when fighting fires as specified by OSHA regulation, 29 CFR 1910.1017.

Eye Protection: No requirements but it is use of good practice to avoid eye contact.

Other Protective

Equipment: Handle in accordance with good hygiene and safety practices.

SECTION IX – SPECIAL PRECAUTIONS

Precaution in handling: N/A

SECTION X – DISCLAIMER OF LIABILITY

As the conditions or methods of use are beyond our control, we do not assume any responsibility and expressly disclaim any liability for any use of this material. Information contained herein is believed to be true and accurate, but all or suggestions are made without warranty, express or implies, regarding accuracy of the information, the hazards connected with the use of the material or the results to be obtained from the use thereof. Compliance with all applicable federal, state, and local laws and regulations remains the responsibility of the user.