2007-09 Honda CR-V
Extra Wide Armrest
Installation Instructions
1. Using your fingers, remove the plastic cap from the side of the original armrest (lightly pull around edges until it pops off).
2. Using a 9/16” or 14mm socket with extension, remove original bolt, armrest and plastic washer, which is in between armrest and seat.
3. Using a 14mm open-end wrench, remove the two stop pins. Install the bracket with the two cap screws supplied using the 8mm hex wrench supplied (the threaded shaft of the bracket should be towards the top left).
Tighten securely.
4. Place the large nylon washer over the threaded shaft on the bracket. Place the armrest onto the threaded shaft. Unzip the zipper on the armrest about half way to locate the hole in the side of armrest. Using a 1/2” or 13mm socket and a long extension, install the bolt and small nylon washer into the threaded shaft and tighten in small increments until armrest stays half way up on its own but still goes up and down smoothly.
CAUTION: Do not over tighten the screw and then back off.
Redo the zipper. Installation is complete.