2018 Slurry and Micro-Surfacing Systems Samples 5(A) and 6(B)

2018 Slurry and Micro-Surfacing Systems Samples 5(A) and 6(B)

Data Sheet

Closing Date: September 6th, 2018

We encourage you to use the online data entry system. Or, you may fax 240-436-4899 or mail your data sheet to: John J. Malusky, AASHTO re:source 4441 Buckeystown Pike, Suite A, Frederick, MD 21704. If your laboratory is not registered to enter your results online, or if there are questions, contact AASHTO re:source at or call 240-436-4900.

Enter Test Results in Rows (1) to (13) Below

Moisture Content (As Received) (T255/C566):
Please select the method used: T255 , C566 / Sample 5(A) / Sample 6(B)
Percent Moisture- “As Received” (nearest 0.1%)...... (1)
Determining Mix Time (ISSA TB-113):
Time to “Break” (nearest second)...... (2)
Time to Clear Water Set - Optional (nearest minute)...... (3)
Set and Cure Development By Cohesion Tester (TB-139, D3910, D6372):
Please select the method used: TB-139 , D3910 , D6372
Air temperature of laboratory during testing (nearest °C): ______
Percent relative humidity of laboratory during testing (nearest 1.0 %): ______
Torque Value at Time 30 min (nearest 0.5 kg-cm)
Mode of Rupture: Normal , Near Spin , Spin , Solid Spin ...... (4)
Torque Value at Time 60 min (nearest 0.5 kg-cm)
Mode of Rupture: Normal , Near Spin , Spin , Solid Spin ...... (5)
Torque Value at Time 90 min (nearest 0.5 kg-cm)
Mode of Rupture: Normal , Near Spin , Spin , Solid Spin ...... (6)
Torque Value at Time 120 min (nearest 0.5 kg-cm)
Mode of Rupture: Normal , Near Spin , Spin , Solid Spin ...... (7)
Torque Value at Time 180 min(nearest 0.5 kg-cm)
Mode of Rupture: Normal , Near Spin , Spin , Solid Spin ...... (8)
Wet Track Abrasion (ISSA TB-100, D3910, D6372):
Please select the method used: TB-100 , D3910 , D6372
Loss Corrected to C-100 Mixer: (Corrected loss in g/f2)...... (9)
Measurement of Excess Asphalt in Bituminous Mixtures by Loaded Wheel
and Sand Adhesion (ISSA TB-109):
Cycle number where “audible tackiness” is determined...... (10)
Mass of adhered sand (TB-109 only) (nearest 0.1 g)...... (11)

(Continued on Following Page)

Measurement of Stability and Resistance to Compaction, Vertical and Lateral Displacement
Of Multilayered Fine Aggregate Cold Mixes (Loaded Wheel Tester)
(ISSA TB 147, ASTM D6372)
Please select the method used: TB-147 , D6372
Percent vertical displacement as percent of original thickness (nearest 0.1%)...... (12)
Percent lateral displacement as percent increase of width (nearest 0.1%)...... (13)

Please report the following information to identify your laboratory:

Name:
Lab Number:
City, State, Country:
Submitted by:
Phone: