2014 Tri State Ohio Valley Mine Rescue

NMRA Post # 6

Bio-Pak 240 R Written Examination

  1. Oxygen will ____ cause materials to ______without the presence of an ignitionsource.

always, ignitenot, ignitesometimes, burn

  1. The BioPak 240 Revolution is approved when the oxygen cylinder is fullycharged with compressed ______or aviation grade oxygen at _____ psi.

construction, 3010medical, 2660medical, 3000

  1. Always ______for a current ______test date.

look, manufacturerscheck, hydrostaticcheck, manufacturers

  1. Replace the battery when the low battery alarm has activated, after ______ofuse or every 6 months whichever comes first.

100, hours200, days200, hours

  1. The usual scrubber consists of ______and a ______core. Do not reusepreviously used CO2 absorbent cartridges or the rubber gaskets.

pumice, paperlimestone, paperlimestone, plastic

  1. Allow all components to remain ______by the cleaning solution a minimum of 10 minutes.

wettedmoistsoaked

  1. Apply anti-fog solution or _____ to both halves of the ______before every useto ensure mask lens do not scratch.

water, feltwater, chamoissoap, chamois

  1. Do not expose opened CO2 scrubber cartridges to ______air for more than 20minutes.

outsidedryambient

  1. Install each CO2 canister into the SCBA so that the ____ end cap is ______on thetop side of the canister.

red, lookingblue, visiblered, visible

  1. A low battery alarm is indicated by a Red, Green, Blue light sequence followedby a _____ alarm _____ any time the battery will not complete a four-hour mission.

momentary, beepshort, beepshort, chirp

  1. If a quick Turn-Around ______has been performed, the SCBA will functionand is designed to work wet.

CleaningMaintenanceTesting

  1. The RMS will automatically ______once the system pressure has droppedbelow 25 psig.

power, downturn, offpower, up

  1. ______-____ and Dow-111 are the only o-ring lubricants that shall be utilized onthe SCBA components.

Cristo-GreaseSilicone-LubeCristo-Lube

  1. ______Use Dow 111 on any o-ring seal that comes in contact with high-pressure

oxygen.

ALWAYSNEVERSOMETIMES

  1. High breathing ______during ______could be caused by the facepieceexhalation valve sticking closed.

rates, inhalationrates, exhalationresistance, exhalation

  1. High breathing resistance during inhalation could be caused by the facepiece______check valve sticking closed.

inhalationexhalationbreathing

  1. High breathing ______during ______could be caused by the demandvalve in breathing chamber has failed.

resistance, exhalationresistance, inhalationrates, breathing

  1. BioPak weight, ready to use is 34 pounds.

433436

  1. BioPak Carbon Dioxide Scrubber is Dual, single use ______cartridges, non-dusting, non-channeling, non-hazardous.

Limestone PelletsCalcium HydroxideCalcium Pellets

  1. The CO2 Scrubber should be replaced after ___ use.

everymultiple1

Tri State Ohio Valley Mine Rescue Contest

Bio-Pak 240 R

Identification of Parts Test of the Written Exam

2014 Tri State Ohio Valley Mine Rescue

NMRA Post # 6

Bio-Pak 240 R Written Examination

ANSWERS

  1. Oxygen will ____ cause materials to ______without the presence of an ignitionsource.

always, ignitenot, ignitesometimes, burn(SF #9)

  1. The BioPak 240 Revolution is approved when the oxygen cylinder is fullycharged with compressed ______or aviation grade oxygen at _____ psi.

construction, 3010medical, 2660medical, 3000(SF # 12)

  1. Always ______for a current ______test date.

look, manufacturerscheck, hydrostaticcheck, manufacturers(SF # 15)

  1. Replace the battery when the low battery alarm has activated, after ______ofuse or every 6 months whichever comes first.

100, hours200, days200, hours(SF # 20)

  1. The usual scrubber consists of ______and a ______core. Do not reusepreviously used CO2 absorbent cartridges or the rubber gaskets.

pumice, paperlimestone, paperlimestone, plastic(SF # 25)

  1. Allow all components to remain ______by the cleaning solution a minimum of 10 minutes.

wettedmoistsoaked(SF # 31)

  1. Apply anti-fog solution or _____ to both halves of the ______before every useto ensure mask lens do not scratch.

water, feltwater, chamoissoap, chamois(SF # 35)

  1. Do not expose opened CO2 scrubber cartridges to ______air for more than 20minutes.

outsidedryambient(SF # 39)

  1. Install each CO2 canister into the SCBA so that the ____ end cap is ______on thetop side of the canister.

red, lookingblue, visiblered, visible(SF # 41)

  1. A low battery alarm is indicated by a Red, Green, Blue light sequence followed by a _____ alarm _____ any time the battery will not complete a four-hour mission.

momentary, beepshort, beepshort, chirp(SF # 47)

  1. If a quick Turn-Around ______has been performed, the SCBA will functionand is designed to work wet.

CleaningMaintenanceTesting(SF # 51)

  1. The RMS will automatically ______once the system pressure has droppedbelow 25 psig.

power, downturn, offpower, up(SF # 54)

  1. ______-____ and Dow-111 are the only o-ring lubricants that shall be utilized onthe SCBA components.

Cristo-GreaseSilicone-LubeCristo-Lube(SF # 56)

  1. ______Use Dow 111 on any o-ring seal that comes in contact with high-pressure

oxygen.

ALWAYSNEVERSOMETIMES(SF # 57)

  1. High breathing ______during ______could be caused by the facepieceexhalation valve sticking closed.

rates, inhalationrates, exhalationresistance, exhalation(SF 68)

  1. High breathing resistance during inhalation could be caused by the facepiece ______check valve sticking closed.

inhalationexhalationbreathing(SF # 71)

  1. High breathing ______during ______could be caused by the demandvalve in breathing chamber has failed.

resistance, exhalationresistance, inhalationrates, breathing(SF73)

  1. BioPak weight, ready to use is 34 pounds.

433436(SF # 76)

  1. BioPak Carbon Dioxide Scrubber is Dual, single use ______cartridges, non-dusting, non-channeling, non-hazardous.

Limestone PelletsCalcium HydroxideCalcium Pellets(SF # 78)

  1. The CO2 Scrubber should be replaced after ___ use.

everymultiple1(SF # 85)

Tri State Ohio Valley Mine Rescue Contest

Bio-Pak 240 R

Identification of Parts Test of the Written Exam