1. PRODUCT and COMPANY IDENTIFICATION
Product: J0753K Checker pH Meter Complete
Kit
Product Code(s): J0753D2, J0753D3, J0753D5 components
Supplied by: Jorgensen Laboratories, Inc.
1450 North Van Buren Avenue, Loveland, CO 80538
Ph: (800)525-5614 Fax: (970)663-5042
2. HAZARDS IDENTIFICATION
ALL COMPONENTS
Non-hazardous products as specified in Directives 67/548/EEC and 1999/45/EC
Non-hazardous products as specified in OSHA Regulation 29CFR 1910.1200
Non-hazardous products as specified in Canadian Regulation SOR/88-66
Non-hazardous products as specified in European Regulation (EC) 1272/2008
3. IDENTIFICATION OF INGREDIENTS
J0753D2 Buffer Solution pH 4.01 Aqueous Solution
pH 4.0 buffer solution ± 0.01@ 25°C/77°F
J0753D3 Buffer Solution pH 7.01 Aqueous Solution
pH 7.0 buffer solution ± 0.01@ 25°C/77°F
J0753D5 Storage Solution for Electrodes Aqueous Solution
pH 5-7 at 20°C
4. FIRST AID MEASURES
ALL COMPONENTS
INHALATION:
Remove to fresh air. If symptoms occur, seek prompt medical attention
INGESTION:
Wash out mouth with plenty of water, as long as person is conscious. Seek prompt medical attention if symptoms occur.
SKIN CONTACT:
Wash with plenty of soap and water. If irritation develops, seek prompt medical attention.
EYE CONTACT:
Check for and remove contact lenses. Immediately flush eyes with gentle but large stream of water for at least 15 minutes, lifting lower and upper eyelids occasionally. If irritation develops, seek prompt medical attention.
5. FIRE FIGHTING MEASURES
NFPA RATINGS: Health: N/A Flammability: N/A Reactivity: N/A
FIRE EXTINGUISHING MEDIA – Use water, foam, dry powder or carbon dioxide.
Special Risks – Non-combustible
Special PPE – Wear suitable protective clothing and a self-contained breathing apparatus as necessary; leave contaminated area as soon as possible
Additional Information – Contain escaping vapors with water
6. ACCIDENTAL RELEASE MEASURES
ALL COMPONENTS
Personal Precautions – None other than proper laboratory techniques and practices
Environmental Precautions – None other than proper laboratory techniques and practices
7. HANDLING and STORAGE
ALL COMPONENTS
HANDLING – Use proper PPE and observe proper laboratory techniques and practices
STORAGE – Keep container(s) tightly closed and protected from direct sunlight.
Store at room temperature (15°C - 25°C)
8. EXPOSURE CONTROL and PERSON PROTECTION
ALL COMPONENTS
PPE – Wear proper protection for body, hands, face, eyes; and practice proper laboratory techniques and practices
Gloves – rubber or plastic – wash hands after handling any components in this kit
Eyes – goggles or face mask
Respiratory PPE – required when vapors/aerosols are generated
Change any contaminated clothing and wash any exposed areas of skin as soon as possible
9. PHYSICAL and CHEMICAL PROPERTIES
J0753D2 – Buffer Solution 4.01
APPEARANCE: Colorless or red liquid
ODOR: Odorless
MELTING POINT: N/A
BOILING POINT: ~100°C
SOLUBILITY: Miscible with water
pH: 4.01 at 25°C
FLASH POINT: N/A
J0753D3 – Buffer Solution 7.01
APPEARANCE: Colorless or green liquid
ODOR: Odorless
MELTING POINT: N/A
BOILING POINT: ~100°C
SOLUBILITY: Miscible with water
pH: 7.01 at 25°C
FLASH POINT: N/A
J0753D5 – Storage Solutions for Electrodes
APPEARANCE: Colorless liquid
ODOR: Odorless
MELTING POINT: N/A
BOILING POINT: ~100°C
SOLUBILITY: Miscible with water
pH: 5-7 at 25°C
FLASH POINT: N/A
10. STABILITY and REACTIVITY
ALL COMPONENTS
Conditions to be avoided – Do not heat beyond the boiling point. Stable in the recommended storage conditions.
Hazardous polymerization – Will not occur
Hazardous decomposition products – See Section 5 in the event of fire
.
11. TOXICOLOGICAL INFORMATION
ALL COMPONENTS
Product toxicity – Quantitative data on the toxicity of this product is not available
Potential Heath Effects – Hazardous properties cannot be excluded but are relatively unlikely because of the low
concentration of the dissolved substances when the product is handled appropriately
using proper laboratory technique.
12. ECOLOGICAL INFORMATION
ALL COMPONENTS
No ecological problems are to be expected when the product is handled, used, and stored with proper care and attention and according to proper laboratory technique.
13. DISPOSAL INFORMATION
ALL COMPONENTS
All components of this product may be safely disposed of as ordinary refuse.
14. TRANSPORT INFORMATION
ALL COMPONENTS
Not regulated.
15. REGULATORY INFORMATION
ALL COMPONENTS
Complies with European Regulations (EC) No. 1907/2006, and No. 1272/2008
Complies with European Council Directives 67/548/EEC and 1999/45/EC
Complies with OSHA regulation 29 CFR1910.1200
Complies with Canadian Regulation SOR/88-66
16. OTHER INFORMATION
PRODUCT USE:
For laboratory use only; not for household use.
DISCLAIMER:
Jorgensen Laboratories, Inc. provides the information contained herein in good faith but makes no representation as to its comprehensiveness or accuracy. This document is intended only as a guide to the appropriate precautionary handling of the material by a properly trained person using this product. Individuals receiving the information must exercise their independent judgment in determining its appropriateness for a particular purpose.
JORGENSEN LABORATORIES, INC. MAKES NO REPRESENTATIONS OR WARRANTIES, EITHER EXPRESSED OR IMPLIED, INCLUDING WITHOUT LIMITATION ANY WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE WITH RESPECT TO THE INFORMATION SET FORTH HEREIN OR THE PRODUCT TO WHICH THE INFORMATION REFERS, ACCORDINGLY, JORGENSEN LABORATORIES, INC. WILL NOT BE RESPONSIBLE FOR DAMAGES RESULTING FROM USE OF OR RELIANCE UPON THIS INFORMATION.
Updated 06/2015